User manual HANDHELD SYSTEMS HUSKY FS2

[. . . ] 10 BACKLIGHT KEY: press to illuminate the screen for use in low light. You may need to press L at the same time (depending how your FS/2 is set up). 11 TYPING KEYS: type letters, or symbols and functions when used with S (SHIFT). 12 BACKSPACE KEY: press to erase typing. [. . . ] Or fit three new AA size Alkaline batteries (see Replacing batteries). Charging batteries Charging is recommended before each working shift. CAUTION: DO NOT ATTEMPT TO RECHARGE NON-RECHARGEABLE BATTERIES. Check that rechargeable batteries are fitted to your FS/2, and are oriented correctly. G Turn the unit off. G G G G G Plug the AC adaptor into the AC supply. Leave the unit to recharge, preferably for 8 hours. Turn off or disconnect from the AC supply. Alternatively, if your system includes the FS/2 Charging and Communications Rack, you can recharge a unit by placing it on the Rack. Replacing batteries G G G G G Turn your FS/2 off. Remove the battery cap by using a suitable coin. Do not allow rain or moisture into the battery compartment. Tilt the unit to slide out the batteries. Slide the fresh batteries into the battery compartment, positive end first. If you are fitting AA size batteries, it is advisable to fit the packing sleeve supplied with the FS/2. Seat it with finger pressure first and make sure that it has engaged the screw threads before tightening it with a suitable coin. Turn on and check operation. G G G If you can't turn on, contact your system provider. G After changing batteries, you MUST ensure that the battery type, capacity and power management are correctly set. (Refer to your application's user instructions. ) CAUTION: If you have changed from rechargeable to non-rechargeable batteries, warn anyone you give the unit to. Non-rechargeable batteries must NOT be recharged. Always use batteries of the same type and charge state - don't mix fresh batteries with used batteries, or rechargeable batteries with non-rechargeable ones. Observe the instructions printed on the battery. Replace only with batteries approved by your FS/2 supplier. ATTENTION: Dispose of or recycle used batteries according to the manufacturer's instructions. Nickel-Cadmium rechargeable batteries must be recycled, or disposed of properly. CAUTION: BATTERY CHEMICAL LEAKAGE IS CORROSIVE. [. . . ] Your application may provide a RESET facility. If the unit is very dirty or wet, clean it as described in CLEANING. CAUTION: There are no user serviceable parts inside the FS/2. Do not attempt to open. Electromagnetic Compatibility The FS/2 complies with EN55022 Class B. This device complies with part 15 of the FCC Rules. [. . . ]