User manual HANDHELD SYSTEMS HUSKY FS3

[. . . ] Read ALL this leaflet before using your FS3. It contains essential information about getting started, and setting up. CAUTION - battery types: it is very important to set up the FS3 correctly for the battery type you are using. Refer to the section THE BATTERY inside this leaflet. HUSKY battery types supplied with your FS3 can be as follows: l NiCd (Nickel Cadmium) rechargeable battery pack, colour coded black. [. . . ] · The FS3 is normally supplied with SPM selected (standard power management). If this is acceptable, confirm that SPM is displayed, and skip to step 8 below. · If you wish to change the charging mode, press G to select APM (or H for FPM). Press E to go to the Power Parameters menu. · Use H to adjust Power remaining to 0% (skip this step if you selected FPM). · Use J to select the Battery chargeable option, then press H to select Yes. Note: If non-rechargeable alkaline batteries are fitted, you must select No. · Press J to select Battery capacity. Use G or H to adjust the value to 1600 mAh for a NiCd battery, or 2100 mAh for a NiMH battery. · Use J to select Charging Authorisation, and H to select Level 4 in APM (or Level 3 in FPM). Note: If non-rechargeable alkaline batteries are fitted, you must select Level 1. Charge the battery: press P to turn off the FS3 and leave it connected to the FS3 AC Adaptor or Rack to charge for at least 8 hours (APM or FPM) or overnight (SPM). Note: If non-rechargeable alkaline batteries are fitted, you must skip step 9. Note: After an application has been loaded into FS3, access to SETTING UP functions may be different. Refer to instructions provided with your application. CONTROLS Note: Your application's user instructions may supplement the following information. Turning on and off Press P to turn on, or off. To conserve power, the FS3 turns off automatically if you have not pressed any keys for a short while. Screen contrast Adjust the screen contrast for optimum readability, especially at temperature extremes. Hold down either S (SHIFT) key and press G to increase contrast or H to decrease contrast. Screen backlight In low ambient light, press L to turn the backlight on. You may need to press L at the same time (depending how your FS3 is set up). The backlight turns off automatically after a short time, to conserve power. Data entry To type numbers or letters, press the appropriate keys. To delete characters you've just typed, press the B (BACKSPACE) key. To select the characters or functions shown above the keys, hold down either S (SHIFT) key and then press the appropriate key. Moving the cursor Software applications will normally allow you to move the cursor a character or line at a time, using the arrow keys: I, J, G and H. To move the cursor up or down several lines, use Q and R. Resetting the FS3 Caution: Resetting the FS3 may lose your recent data entries. You should not need to reset the FS3 in normal operation - use this procedure in emergency only. [. . . ] Do not attempt to open. AC POWER ADAPTOR The FS3 (or the FS Communications & Charging Rack) is normally supplied with a HUSKY AC Power Adaptor (power supply). CAUTION: Read and understand the following instructions before using the ac power adaptor. · · · · · · · · · · · · · · Hazardous voltages inside, no user serviceable parts inside, do not attempt to open. Avoid liquid spillage, do not connect if suspected damp. This special adaptor should never be replaced by an alternative unapproved model, as this could be hazardous or damage may result. [. . . ]