User manual HANDHELD SYSTEMS HUSKY MP2500

[. . . ] Read ALL this leaflet before using your MP2500. It contains essential information about getting started, and setting up. CAUTION - battery types: it is very important to set up the MP2500 correctly for the battery type you are using. Refer to the section THE BATTERY inside this leaflet. [. . . ] Note: If non-rechargeable alkaline batteries are fitted, you must select disabled. Charge the battery: press P to turn off the MP2500 and leave it connected to the MP2500 AC Adaptor or Rack to charge for 15 hours (e. g. Note: If non-rechargeable alkaline batteries are fitted, you must skip step 9. Note: After an application has been loaded into MP2500, access to SETTING UP functions may be different. Refer to instructions provided with your application. CONTROLS Note: Your application's user instructions may supplement the following information. Turning on and off Press P to turn on, or off. To conserve power, the MP2500 turns off automatically if you have not pressed any keys for a short while. Screen contrast Adjust the screen contrast for optimum readability, especially at temperature extremes. Hold down either S (SHIFT) key and press G to increase contrast or H to decrease contrast. Screen backlight - option If the backlight option is fitted (refer to your system provider for more details): In low ambient light, press L to turn the backlight on. You may need to press L at the same time (depending how your MP2500 is set up). The backlight turns off automatically after a short time, to conserve power. Data entry To type numbers or letters, press the appropriate keys. To delete characters you've just typed, press the B (BACKSPACE) key. To select the characters or functions shown above the keys, hold down either S (SHIFT) key and then press the appropriate key. Moving the cursor Software applications will normally allow you to move the cursor a character or line at a time, using the arrow keys: I, J, G and H. To move the cursor up or down several lines, use Q and R. Resetting the MP2500 Caution: Resetting the MP2500 may lose your most recent data entries. You should not need to reset the MP2500 in normal operation - use this procedure in emergency only. Report the problem to your system provider. If the MP2500 locks up or fails to operate, you MAY need to reset it as follows: Refer to the previous section SETTING UP. Carry out step 3, Reset the MP2500 and step 4, Starting MS-DOS. If this fails, try another set of Alkaline batteries or (charged) battery pack (see Replacing the Battery). If this does not help, contact your system provider for assistance. LOADING SOFTWARE Your system provider may have already loaded the application software before issuing the MP2500 to you. Software is normally loaded onto an MP2500 by downloading files from a PC. A suitable cable to connect between the PC and the MP2500. HUSKY approved cables are available via your system provider. The HUSKY file transfer utility, HCOM, is provided for the MP2500. [. . . ] If you have dropped the MP2500, check that the case and seals are intact. · Gently rinse the unit under clean running water (no more than hand hot, 40°C). The HUSKY adaptor should never be replaced by an alternative unapproved model - this could be hazardous or cause damage. Inspect the adaptor before connecting, do not use if there are signs of damage or deterioration. [. . . ]