User manual HANDSPRING VISOR PHONE

[. . . ] VisorPhoneTM Module User Guide Copyright Copyright © 2000 - 2001 Handspring, Inc. Handspring, Springboard, Visor, VisorPhone, the Handspring logo, and the Springboard logo are trademarks of Handspring, Inc. , and may be registered in some jurisdictions. Graffiti, HotSync, and Palm OS are registered trademarks of Palm, Inc. All other trademarks are the property of their respective owners. Disclaimer and limitation of liability Handspring, Inc. [. . . ] My VisorPhone won't turn on s Make sure your VisorPhone is inserted firmly in the Springboard expansion slot. Make sure your VisorPhone battery isn't drained. When you turn on your VisorPhone, hold down the power button for at least two seconds, until you hear a beep. Turn on your handheld to make sure that the handheld batteries aren't drained. Low batteries will prevent your VisorPhone from turning on. Make sure your SIM card is properly inserted. The metal contacts must face down (away from the battery), and the side with the corner cut must slide into the SIM slot first. For details, see "Step 2: Insert your SIM card into your VisorPhone" on page 3. Contact your service provider for a new card. 85 s s s I get a message that my SIM card is missing when I turn on my VisorPhone s s Troubleshooting and Maintenance My VisorPhone requires an unlocking code (PIN), but I didn't set one s Your service provider may have set the locking code before you received your VisorPhone. Enter the default unlocking code (PIN) and then tap OK. In North America, the default unlocking code is usually 1234 or 1111. If this doesn't work, contact your service provider. Note: It is actually your SIM card that is locked, not your VisorPhone. s If you see the Unblock Phone screen instead of the Unlock Phone screen, you entered the unlock code (PIN) incorrectly three times, and your VisorPhone is now blocked. Contact your service provider to obtain the unblock code. If you enter the unblock code (PUK) incorrectly ten times, your SIM is permanently disabled. I called my service provider to enable my phone service, but it still doesn't work Some service providers require 24 hours or more to activate your phone service. If it has been longer than your service provider's activation period, report the problem to your service provider. 86 Troubleshooting and Maintenance My phone number isn't on the Phone Info screen My VisorPhone won't register to the network Your service provider may need to install your phone number onto your SIM card. Contact your service provider to see if they can send a message to your VisorPhone that writes your phone number onto your SIM card. s You are probably outside a network coverage area. Try using another GSM phone to verify whether coverage is available in your current location. If coverage is available in your location, try your SIM card in another GSM phone. If it still doesn't, work, your SIM card may be malfunctioning. Contact your service provider for another SIM card. Turn off your VisorPhone, and then turn it on again. If a dialog appears asking if you want to search for a network, tap Yes. [. . . ] Interference to Other Electronic Devices RF energy may affect improperly installed or inadequately shielded electronic operating and entertainment systems in motor vehicles. Check with the manufacturer or representative to determine if these systems are adequately shielded from external RF energy. Also check with the manufacturer of any equipment that has been added to the vehicle. Turn your radio OFF before boarding any aircraft to prevent possible interference to aircraft systems. [. . . ]