User manual HANNA INSTRUMENTS HI 9063

[. . . ] If you need additional technical information, do not hesitate to email us at tech@hannainst. com. These instruments are in compliance with the directives. FUNCTIONAL DESCRIPTION Range (*) Resolution Accuracy (@20°C/68°F) Typical EMC Deviation Display Battery Type Life Probe Environment Dimensions Weight SPECIFICATIONS -50. 0 to 199. 9°C / 200 to 1350°C -58. 0 to 399. 9°F / 400 to 2462°F 0. 1°C (up to 199. 9°C) / 1°C (outside) 0. 1°F (up to 399. 9°F) / 1°F (outside) ±0. 2% F. S. excluding probe error ±3°C (with HI 766 probes) ±6°F (with HI 766 probes) Dual-line LCD 4 x 1. 5V AA (IEC LR6) approx. [. . . ] Reproduction in whole or in part is prohibited without the written consent of the copyright owner, Hanna Instruments Inc. , Woonsocket, Rhode Island, 02895 , USA. Hanna Instruments reserves the right to modify the design, construction and appearance of its products without advance notice. GENERAL DESCRIPTION HI 9063 is a waterproof, microprocessor-based, K-type thermocouple thermometer, which provides very accurate measurements in a wide range of temperatures. The meter is also provided with low battery detection and BEPS (Battery Error Preventing System), which turns the unit off when the batteries are discharged avoiding erroneous readings caused by low battery level. HI 9063 features include autoranging capability, dual-level LCD for simultaneously displaying of maximum and minimum measured temperatures, °C/°F selection button and hold function. Each meter is supplied complete with 4 x 1. 5V AA batteries and instruction manual. 1. HI/LO values reset key FACTORY RECALIBRATION All Hanna Instruments thermometers have been accurately pre-calibrated at the factory. It is generally recommended to have all thermometers recalibrated at least once a year. For an accurate annual recalibration, contact your nearest Hanna Service Center. 1. Measuring scale, °C or °F OPERATIONAL GUIDE INITIAL PREPARATION Each meter is supplied complete with batteries. Remove the back cover, unwrap the batteries and install them while paying attention to their polarity. Connect a K-type thermocouple probe to the meter. To switch on, press the ON/OFF key on the front of the meter. If the meter does not come on, make sure that the batteries are correctly installed. The thermometer will carry out a self diagnostic test routine, the LCD will show all segments for a few seconds (or as long as ON/OFF is held), followed by the percentage indication of the remaining battery life. The thermometer then enters normal measurement mode. If a temperature probe is plugged in, the meter displays the measured temperature. If no probe is plugged in, or if reading is over-range, the display shows flashing dashes. If a measurement is slightly over the range of the meter specifications, the display flashes the closest full-scale value. To switch the thermometer OFF, press the ON/OFF key. HIGH/LOW TEMPERATURES The maximum and minimum temperatures are continuously monitored and displayed in the lower portion of the LCD. [. . . ] To avoid electrical shock, do not use these instruments when voltage at the measurement surface exceeds 24VAC or 60VDC. To avoid damage or burns, do not perform any measurement in microwave ovens. HOLD MODE The HOLD function is activated by pressing the HOLD key. The measured temperature is held on the display until HOLD is pressed again. [. . . ]