User manual HARMAN KARDON CITATION 12

[. . . ] CONNECTING THE 7. 0 A/V Controller to the ADP 303 The ADP 303 includes loop through audio connection jacks for receiving the audio outputs from the Citation 7. 0 and routing them through the ADP 303. The audio outputs of the ADP 303 are then connected to the amplifier channel inputs of your left, right, center, left surround, right surround, and subwoofer amplifiers. Before making any connections, first, power off all components in your audio system, especially power amplifiers. [. . . ] Before making any connections, first, power off all components in your audio system, especially power amplifiers. Follow the diagram below for making the proper connections between your Citation 7. 0 and the ADP 303. 7. 0 AV CONTROLLER BACK PANEL AUDIO OUTPUTS FRONT L CENTER FRONT SURROUNDS SIDE BACK R MONO SUB CITATION AUDIO OUTPUTS TO SIDE CHANNEL AMP INPUTS IF USED ADP 303 AUDIO INPUTS ADP 303 AUDIO OUTPUTS ADP 303 DOLBY DECODER BACK PANEL IN OUT AC - 3 RF IN L R L R SURROUND CENTER SUB WOOFER FROM RF DIGITAL OUTPU T OF LASER DISC PLAYER TO LEFT FRONT AMP INPUT TO RIGHT FRONT AMP INPUT TO LEFT SURR AMP INPUT TO RIGHT SURR AMP INPUT TO CENTE R FRONT AMP INPUT TO SUB WOOFER AMP INPUT "Y" OUT MONO SUB OUT FOR USE WITH STEREO SUBWOOFERS If you are using the side channel outputs of your Citation 7. 0 controller, leave these channels connected directly to the side channel amplifier inputs. These channels will not be used for Dolby Digital playback of the ADP 303 digital processor. They will, however, still be used for all playback of 2 channel modes such as 6 AXIS, 70 MM, Dolby, and THX . If your system side channel speaker locations are behind the primary listening position, you may elect to route the side channel outputs of the 7. 0 processor through the ADP 303. In this scenario, the back outputs of the 7. 0 processor will remain directly connected to your amplifier inputs and will not be used for Dolby Digital playback. CONNECTING SUB-WOOFERS If you are using sub-woofers, the ADP 303 may be configured for a mono sub-woofer only. We recommend the use of a SPL meter to accurately set up and match audio levels of the two units. USING the ADP 303 For Dolby Digital Playback, the ADP 303 should be "ON" and the appropriate input selected on the ADP 303. Volume control is adjusted manually on the front panel of the ADP303. When 6 AXIS or any other matrix surround mode is in use, the ADP 303 will be in a "By-pass" mode and the 7. 0 will operate as if the ADP 303 was not in the circuit. "By Pass" is accessed on the ADP 303 by pressing the "By-pass" button located on the ADP 303 front panel. The ADP 303 will also be in the "By-Pass" mode when the "Power" to the unit is "OFF". You will hear a popping sound when "By-pass" is engaged and disengaged. [. . . ] "By Pass" is accessed on the ADP 303 by pressing the "By-pass" button located on the ADP 303 front panel. The ADP 303 will also be in the "By-Pass" mode when the "Power" to the unit is "OFF". You will hear a popping sound when "By-pass" is engaged and disengaged. [. . . ]