User manual HARMAN KARDON CITATION 7.0 Connection Guide

[. . . ] CITATION a madrigal audio labs company CITATION 7. 0 TO ADP 303 HOOK-UP INSTRUCTIONS The following are some specific instructions to connect your Citation 7. 0 A/V Controller with the Harman Kardon ADP 303 digital decoder. When connected, the ADP 303 will provide Dolby Digital playback in conjunction with the audio/video switching and matrix surround processing of the Citation 7. 0 A/V Controller. [. . . ] If your system uses two Subwoofers, connect a "Y" adapter to the sub out of the ADP 303 to drive left and right sub-woofer channels. The ADP includes high pass filters which are engaged on the back of the unit. For most speaker configurations, switch this "speaker mode" setting to "small" on all channels. The "small" position should be used for all Citation speaker combinations. Sub-woofer levels on the ADP 303 are adjusted by ear. Caution should be used when adjusting this control point. Too high of a bass level will cause your sub-woofers to "POP" or worse, damage your subwoofers. Start the level in the full counter clockwise position and slowly raise it to the desired bass level. 3. CALIBRATION The calibration of the ADP 303 is performed independently of the Citation 7. 0 A/V Controller. After the 7. 0 is connected and calibrated, follow the instructions included with the ADP 303 for proper set up and calibration of the digital processor. [. . . ] During Dolby Digital playback, the 7. 0 should be selected to the appropriate input for video switching purposes and the volume level should be set all the way down. This is necessary if both side and back channels of the 7. 0 are used in the system. [. . . ]