User manual HARMAN KARDON GPS-200 (ITALY) [GPS-200IT]

[. . . ] guide + play TM GPS-200GSEC, GPS-200IT and GPS-300WE Portable Touchscreen Navigation System and A/V Media Player User Manual Contents Introduction . 18 Traffic Message Channel "TMC" (Not GPS-200IT) . 21 ­ 25 Loading Media on Your SD Card . 31 Battery Notes: The Harman Kardon® GPS-200/300 uses a lithium-polymer battery. [. . . ] (See Changing Navigation Settings, on page 18. ) ROUTE OPTIONS BUTTON: Displays the ROUTE OPTIONS screen (right). ROUTE OPTIONS SCREEN VIEW ROUTE BUTTON: Shows a map view of the entire navigation route. (See 2D Map View illustration on page 15. ) VIEW TURN-BY-TURN BUTTON: Displays a detailed list of each turn for the entire trip (right). The list shows the direction of each turn and how far to drive on each leg of the journey. Touching the button for one leg of the journey and then touching the SHOW button will display a map showing that particular leg of the trip. Touching the button for a particular turn or leg on the detailed list screen and then touching the AVOID button will display the AVOID screen (right). This screen lets the GPS200/300 recalculate a new route that avoids a particular maneuver or road, or recalculate a certain distance on the road that you selected. NOTE: Voice guidance continues when the GPS-200/300's screen is in the Turn-By-Turn view. DETOUR NEXT TURN BUTTON: Recalculates your route, avoiding the next turn. Use this to avoid construction sites, traffic jams, etc. ADD DESTINATION BUTTON: Lets you add another destination at the end of your trip. See Planning a Trip, on page 9. User Manual guide + play TM GPS-200/300 Changing Navigation Settings Touching the NAVIGATION SETTINGS button displays the NAVIGATION SETTINGS screen (right). AVOIDANCES: When the GPS-200/300 calculates navigation routes, you can set it to always avoid the following: · U-turns · Unpaved roads · Toll roads · Roads requiring permits (Backroads) · Highways · Border crossings · Ferries · Traffic (TMC) (Not available in GPS-200IT. ) NOTE: The GPS-200/300 comes from the factory with the UNPAVED ROADS avoidance set to ON. DISTANCE UNITS: You can set the GPS-200/300's distance units to kilometers/meters, miles/feet or miles/yards. This affects the units shown on the screen, and the units given during voice navigation prompts. ROUTE PRIORITY: When the GPS-200/300 calculates navigation routes, you can set it to give priority to either the SHORTEST DISTANCE or the SHORTEST TIME . GPS DATA: This screen displays the following information: Your Position Relative to the Nearest 12 GPS Satellites Relative Signal Strength of Nearest 12 GPS Satellites Your Current Altitude (Above/Below Sea Level) Accuracy of GPS Satellite Data User Manual 18 Your Current Global Position (in Latitude and Longitude) NOTE: Your GPS-200/300 will lose contact with the GPS satellites whenever you turn its power off. After turning the power back on, you will need to go outside to receive the GPS signal again before the navigation functions will operate. guide + play TM GPS-200/300 ! Using the Safety Camera warning function may be prohibited by law in certain countries. The user should determine whether the use of this feature is governed by any law prior to its use. SAFETY CAMERA: You can set the GPS-200/300 to warn you against Safety/ Speed cameras along the way. Pressing "Enable" in the Enable Safety Cameras screen opens an information/Warning window showing the internet address "www. speedcamupdate. com", where you may download the necessary information against a subscription charge. Also, you are warned that the function may be prohibited in certain countries. You have to connect the GPS Unit to your PC with the supplies USB-cable to download the information, following the instructions on the homepage. You may select permanent or temporary cameras, or both. Pressing "Yes" in the information/warning window Opens the Enable screen with the Enable button highlighted in blue. Pressing the blue button again will disable the camera function. Once inside the camera screen, you may choose between options regarding Audible Warnings and Visible Warnings. [. . . ] Peel the mounting base adhesive covering. Attach the mounting base to the mounting location. Hold the mounting bracket's base against the mounting base. Push the mounting bracket lever towards the base to lock the bracket to the dashboard. 4. [. . . ]