User manual HARMAN KARDON HE 1000

[. . . ] s Red indicator flickers at random - The HE1000A is designed to receive infrared signals and occasionally it may pick up random infrared "noise. " The random flickering does not cause any harm, unless it appears to interfere with proper response to commands. Try moving or turning the HE1000A Remote Eye so that it is not affected by strong sunlight or light from at television screen. If flickering persists, try turning off the television receiver to see if it is affecting the HE1000A. The HE1000A Remote Eye may be moved away from the television to eliminate problems. [. . . ] Plug the Power Supply into the PWR jack on the Connecting Block. Plug the Power Supply into an unswitched AC outlet. Operation Use the Reomote Eye as you would use the remote sensor window on any audio or video component. Simply point the handheld remote control at the Remote Eye and press the proper button. The Remote Eye dose not change the way your remote controls work. The maximum operating distance between the remote control and the Remote Eye will be different for each remote control and will be different than the range of the remote control when pointed directly at the audio or video component. HK-Cassettendeck GENERAL INSTRUCTIONS Use the Correct AC Voltage. Connecting the unit to an supplying a higher voltage may create a fire hazard. Handle the Power Cord Gently s To disconnect the power supply from the AC outlet, pull on the power supply itself, not on the cord. s Disconnect the power supply from the AC outlet whenever the unit is to be left unused for an extended period of time. s Do not place furniture or other heavy objects on the cord, and avoid dropping heavy objects on it. Place the unit on a firm and level surface or fasten it securely in place. Avoid installing it: s In moist or humid places: s Close to heating equipment or in places exposed to direct sunlight. Before moving the unit, be sure to unplug the power supply from the AC outlet and disconnect all wires. Tampering with internal components can cause fire or shock, and may void your warranty. If water or small objects enter the unit, unplug the power cord immediately. Using the unit under such conditions may cause a fire or shock hazard. Remove dust by wiping the unit with a soft, dry cloth. If necessary, use a soft cloth lightly dampened with mild soapy water; then wipe with a dry cloth. Never use benzene, thinner, alcohol or other volataile agents, and avoid spraying insecticides near the unit. One-Foot Cable Patch Cord Figure 1 Connecting Block 2. [. . . ] They are both required should the unit ever need warranty repair. Placement The Remote Eye may be placed on any flat, level surface or it may be Audio or video Component One-Foot Cable Figure 2 Position the emitter over the remote control sensor window on any of these additional components (audio or video unit). Peel off the paper backing to expose the clear adjesive. The clear adhesive film will hold it in place. [. . . ]