User manual HARTAN RACER PLUS

[. . . ] Handlebar Handlebar catch Safety turn lock Handle-folding lock button Wheel retention Lock-type-swivel wheel Parking brake Adjustable suspension system Readjustment of hand brake Silently adjustable hood Silently adjustable hood Sun canopy Hood and safety bar Tilt-adjustable backrest Safety belt Adjustable footrest Footrest extension Fall-out protection Automatic lock for upper section Congratulations on your purchase You want your baby to feel safe and secure, that's why you have purchased a high-quality product. Products are manufactured with the greatest possible care and monitored constantly by rigorous quality control assuring that your pram will provide life-long satisfaction. The textiles used for our products have been tested for harmful substances (chemical residues) according to the industry's own 'Öko-Tex-Standard 100' to guarantee that all the fabric parts of your pram are safe for your baby. Please do not use this pram before reading the instructions carefully, and keep these instructions for queries or future reference. [. . . ] When inserting it, make sure the safety bar locks into place correctly and be careful not to pinch any of the fabric parts. By pressing the buttons, the safety bar position can be changed. The hood bar 10 of the strol14 ler and the safety bar are not suitable for carrying the pram. Adjusting the backrest By lifting the back clip 13 at the rear, the backrest can be adjusted from sitting to reclining position in close steps. When adjusting the backrest, take care that no movable parts jam the baby's limbs, or fingers, etc. Finally, make sure the backrest has reengaged properly. Always use the crotch belt D in combination with the waist strap E. Remember to tighten the seat belt when it slacks, which is done by means of the adjuster buckles. For reasons of safety, pass the belt buckle through the shackle F when closing the safety belt. Adjusting the footrest By pressing the two red safety buttons 15 at the same time, the footrest can be lowered. To do this, pull the two red pins 16 and turn the footrest by 180°. In case the carrycot is attached to the frame, the footrest should always be in horizontal position, as an additional protection preventing it from slipping out. secure the carrycot according to the operating instructions. Automatic lock for upper section 19 Place the carrycot or stroller unit upon the chassis in a way that the two lateral pins engage in the respective slots on each side. then push the upper section right up to the stop. The catching pins on both sides engage automatically, which is indicated each time by a click sound. By pulling the upper section horizontally, check before use whether it is fixed correctly!If the red safety point can still be seen, the upper-section lock has not yet completely closed!Pull the locking lever downwards until it snaps into place to open the lock and to remove the upper section. As an additional protection preventing the baby from falling out of the carriage, secure the hood to the metal back. To do this, join the two grommets 17 to their respective turn-lock fasteners, and the hook lock 18 to the metal ring on the back plate as well. Suitability for your child The Racer plus stroller unit is designed to carry a child from the age of 6 months, and up to 15kg in weight. [. . . ] Then continue to inflate it to the proper pressure. 2 YEARS warranty This product is guaranteed for a period of 2 years by your contract partner. For possible submission of proof, please keep your receipt, the completed warranty card as well as the hand-over check bearing your signature for the length of the warranty period. These documents must be submitted to qualify for service under the warranty. [. . . ]