User manual HARTAN RACER XLS

[. . . ] Handlebar Handlebar catch Safety turn lock Handle-folding lock button Wheel retention Lock-type-swivel wheels (only S and XLS) Parking brake Adjustable suspension system Automatic lock for upper section Silently adjustable hood Sun canopy Hood and safety bar Tilt-adjustable backrest Safety belt Adjustable footrest Footrest extension Folding carrycot (only XL and XLS) Retractable mounting frame (only XL and XLS) Fall-out protection Congratulations on your purchase You want your baby to feel safe and secure, that's why you have purchased a high-quality product. Products are manufactured with the greatest possible care and monitored constantly by rigorous quality control assuring that your pram will provide life-long satisfaction. The textiles used for our products have been tested for harmful substances (chemical residues) according to the industry's own 'Öko-Tex-Standard 100' to guarantee that all the fabric parts of your pram are safe for your baby. Please do not use this pram before reading the instructions carefully, and keep these instructions for queries or future reference. [. . . ] As an additional protection, the sun visor can be pulled out. Hood and safety bar By pressing the bayonet joint 12, the hood or the safety bar can be pulled out. When inserting it, make sure the safety bar locks into place correctly and be careful not to pinch any of the fabric parts. By pressing the buttons the safety bar position can be changed. The hood bar 9 of the stroller and the safety bar are not suitable for carrying the pram. Adjusting the backrest By lifting the back clip 13 at the rear, the backrest can be adjusted from sitting to reclining position in close steps. When adjusting the backrest, take care no movable parts jam the baby's limbs, or fingers, etc. Finally, make sure the backrest has reengaged properly. Always use the crotch belt D in combination with the waist strap E. Remember to tighten the seat belt when it slacks, which is done by means of the adjuster buckles. For reasons of safety, pass the belt buckle through the shackle F when closing the safety belt. Adjusting the footrest First, press the two buttons 15, located at the right and left side respectively, to fold the footrest down. then raise the footrest to the required position. A number of settings up to the horizontal position can be selected. To prolong the footrest, press the two buttons 16, and pull it out. In case the carrycot is attached to the frame, the footrest should always be in horizontal position, as an additional protection preventing it from slipping out. Do not use mattresses that have more than 2cm in depth. This carrycot is suitable for holding only one baby, which cannot yet sit up on its own, or roll on its side or support itself on hands and knees. Do not use the carrycot if any part is torn or broken. Be aware of the risks posed by open fires or other sources of heat, such as electric heaters, gas flames etc. , if these are in the immediate vicinity of the carrycot. Retractable mounting frame By means of a retractable mounting frame attached from the outside to the bottom of the carrycot 18, the height of the horizontal surface can be optimally adjusted. [. . . ] May just as well damage the floor covering. When parking the carriage in the blazing sun or cramming it in the boot at temperatures of above 40°C, the semi pneumatic tires may flatten or become deformed. tire air loss Tires tend to lose air over time. When blowing up a flat tire, inflate it only halfway first, and make sure the tire is evenly seated, to avoid "wobble". [. . . ]