User manual HARTAN RS ONE S

[. . . ] Before using the pram, make sure the catches are locked in place and the carriage top is secured properly. Negotiating stairs or steps as well as overloading may damage the pram and endanger your child. When parking the pram, make sure the brake is engaged. It is intended to be used exclusively as a means of transport. [. . . ] To assemble the wheel, insert the fastening pin in the holding device, and engage it by a forcible push, which is indicated by a click sound. Adjustable suspension system By turning the selector 8, a "hard" or "soft" position can be selected for suspension. Automatic lock for upper section Place the stroller unit upon the chassis and pull it into the upper-section lock slots on each side 17 until the catching pins on both sides have engaged, which is indicated each time by a click sound. By pulling the upper section horizontally, check before use whether it is fixed correctly!When removing the upper-section, the lock will close automatically. To release the upper-section lock, push the locking cap (see the arrow) back and press the red securing button downwards until it has engaged. When the locking cap is in pushed back position and the red safety point can still be seen, the upper-section lock has not yet closed completely. Adjusting the footrest First, press the two buttons 15, located at the right and left side respectively, to fold the footrest down. then raise the footrest to the required position. A number of settings up to the horizontal position can be selected. To prolong the footrest, press the two buttons 16, and pull it out. In case the carrycot is attached to the frame, the footrest should always be in horizontal position, as an additional protection preventing it from slipping out. Adjusting the backrest By lifting the back clip 13 at the rear, the backrest can be adjusted from sitting to reclining position in close steps. When adjusting the backrest, take care that no movable parts jam the baby's limbs, or fingers, etc. Finally, make sure the backrest has reengaged properly. Always use the crotch belt D in combination with the waist strap E. Remember to tighten the seat belt when it slacks, which is done by means of the adjuster buckles. For reasons of safety, pass the belt buckle through the shackle F when closing the safety belt. As an additional protection preventing the baby from falling out of the carriage, secure the hood to the metal back. To do this, join the two hood grommets 18 to their respective turn-lock fasteners, and the back hooks 19 to the metal ring at the back plate as well. Suitability for your child The RS one S stroller unit is designed to carry a child from the age of 6 months, and up to 15kg in weight. Only use this seat unit when your child is able to sit independently. [. . . ] consequently , colour fading is excluded from the warranty. It is unavoidable that colours sometimes differ slightly from one individual batch to the next, which is why this case will not be covered under the warranty. Knob formation on fabrics: We recommend that you apply general clothes care. As with woollen sweaters, the knobs can easily be removed by using a clothes-brush or burling machine. [. . . ]