User manual HASBRO BALAROO

[. . . ] Activate its full range of features by moving the PLAY/OFF/ DEMO switch to the "PLAY" position. Switch is located on the back of the remote control. The scooter's ON/ OFF switch is located on the bottom of the scooter. [. . . ] The scooter's ON/ OFF switch is located on the bottom of the scooter. Turn on the scooter by moving the switch to the "ON" position. TIP FOR PARENTS: To turn off motor sounds in PLAY mode, press and hold the horn button for 5 seconds or until you hear a tone. Repeat step to turn the sound on again. NOTE: The LED light indicates that the scooter's turned on. The scooter and remote control use battery power whenever their switches are in the "ON" position. To help conserve battery life, move the switches to "OFF" when you're not playing with the toy. PLAYING WITH THE TOY Press button to turn scooter Press button to move scooter forward Press button for scooter sounds BATTERIES TO INSTALL SCOOTER BATTERIES Use a Phillips/cross head screwdriver (not included) to loosen screw in battery compartment cover (screw remains attached to cover). Insert 3 x 1. 5V "AA" or R6 size batteries. Alkaline batteries recommended. TO REPLACE REMOTE CONTROL BATTERIES Use a Phillips/cross head screwdriver (not included) to loosen screw in battery compartment cover (screw remains attached to cover). Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES. TROUBLESHOOTING If your scooter does not respond, please switch OFF and back ON again or replace the batteries in the scooter and remote control. FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. [. . . ]