User manual HASBRO BEYBLADE TOPS DRACIEL

[. . . ] Remove exhausted or dead batteries from the product. Remove batteries if product is not to be played with for a long time. Do not short-circuit the supply terminals. Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. [. . . ] To turn the BEATMIX BUMBLEBEE toy ON, press the button on its back. You will hear a special introduction song and see a LED animation to show you that the toy is "awake" and ready to play!To turn the BEATMIX BUMBLEBEE toy OFF, press and hold the button on its back for three seconds. You will hear a special sound effect and see a LED animation to show you that the toy is shutting down. The button on the back of the toy will light up and stay lit to show you that the toy is ON. The more music and interaction you give this toy, the more energized it will be, and the more it will "talk" to you with the music you record. ON/OFF LISTEN TO TUNES Use the left ankle wheel to control the volume of beats and clip playback. Take the enclosed cable and connect a musical device (CD player, stereo, portable personal music player, computer, video game system, etc. ­ not included) to the Audio Input Jack on the back of the toy's right leg. Adjust the volume on your musical device. Acts as a speaker for your tunes; and 2. If you do not connect a musical device, the toy's sound sensor will also hear music in Volume the room, if music is loud enough. The headlights will flash green to confirm "loop mode. " Then press a button for a sound effect. To stop any beat or effect, press that spot again. Push and hold the left foot again for two seconds, and the headlights will flash red to confirm "single play mode. " Interaction boosts the energy levels of the toy. 5 ENERGY LEVELS The more you play with and interact with your BEATMIX BUMBLEBEE toy, the higher its energy levels will be. When the toy's energy levels are high, you will see a "happy" animation. When its energy levels are low, it will play an "unhappy" animation. If you don't play or interact with the toy for 5 minutes, the toy will "go to sleep, " to preserve battery life. After 60 minutes of no interaction, the toy shuts down completely. During this 60-minute period, energy levels ON/OFF will decrease, so if you're not planning to interact with the toy for a while, turn it OFF: that is, press and hold the button on its back. Important Tips 1. Do not use excessive force to pull or twist the moveable parts on the toy, especially the arms. The toy may react to other sounds or noises that it hears, other than music. Avoid putting the toy near fragile objects or containers of fluid, as the toy likes to move around and could spill something over. [. . . ] pressing the toy's Reset button, and turn the toy on. I cannot fit a cord into the Input Port. The toy only accepts 3. 5 mm stereo output audio cords. I connected headphones to the toy, but I The toy Input port is for input only: it doesn't function as can't hear anything. [. . . ]