User manual HASBRO CANDY LAND 50TH ANNIVERSARY EDITION

[. . . ] Remove seat by pressing both buttons at the same time and lifting the seat up. Attach seat in the "up" position. Push down until the buttons click to lock seat in place. Ride-on Mode 1. Remove seat by pressing both buttons at the same time and lifting the seat off the truck body. [. . . ] Remove seat by pressing both buttons at the same time and lifting the seat off the truck body. Attach seat in the "down" position. Push down until the buttons click to lock seat in place. NOTE: Seat must be in "down" position for child to ride on vehicle. Never allow child to sit or ride on gravel guard. 3. Remove gravel guard by pushing both buttons at the same time and lifting the gravel guard up. 4. Attach the gravel guard in the "up" position by pushing both buttons at the same time and inserting guard vertically into slot, then pushing down on the gravel guard until buttons click and guard is locked in place. Revvin' Beepin' Wheel To attach to SCOOT 'N SCOOP 3-IN-1 RIDE-ON: 1. Make sure gravel guard is locked in the "down" position. If it is in the "up" position, press both buttons at the same time and pull gravel guard up and off the truck body. Attach in the "down" position by pressing buttons and inserting guard horizontally into slot, then pushing down on the gravel guard until buttons click and guard is locked into place. Align tabs on base of WHEEL with slots on top of gravel guard. Trademarks. CAUTION: TO AVOID BATTERY LEAKAGE 1. Be sure to insert the batteries correctly and always follow the toy and battery manufacturers' instructions; 2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries; 3. Always remove weak or dead batteries from the product. IMPORTANT: BATTERY INFORMATION Please retain this information for future reference. Batteries should be replaced by an adult. CAUTION: 1. Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by matching the + and ­ polarity markings. Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline batteries. Remove exhausted or dead batteries from the product. Remove batteries if product is not to be played with for a long time. [. . . ] Remove exhausted or dead batteries from the product. Remove batteries if product is not to be played with for a long time. Do not short-circuit the supply terminals. Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. [. . . ]