User manual HASBRO CHUTES AND LADDERS VCR

[. . . ] Released electrolyte is corrosive and may cause damage to the eyes and skin. Exercise care in handling batteries to prevent shorting the battery with such conducting materials as rings, bracelets and keys. The battery or conductor may overheat and cause burns. Do not attempt to recharge the battery identified for use with this product. [. . . ] You should have the answering system, AC adaptor, standard telephone line cord, wall mounting bracket, clear table mount and Owner's Manual. Insert one end of the telephone line cord into the line jack (marked LINE on the rear side of the Answering System) and the other end into the house telephone jack. Connect the telephone line cord of your telephone to the telephone connection jack (marked TEL) on the rear side of the Answering System. Insert the small plug on the end of the AC adaptor into the jack (marked POWER on the rear side of the Answering System). Note: Use only with a Class 2 power Source. Input 120V A. C 60Hz Output 9V A. C 4VA 6. Plug the AC adaptor into a standard 120V AC wall outllet. The message display will count up from 0 to 15. A beep will be heard and the display will read "0" and "CL" alternatively. Lift the handset of your telephone and confirm that you have a dial tone. ( If you do not hear a dial tone, review steps 3 through 6 ) INSTALLATION OF BATTERY The system uses 5x1. 5V LR44 or G13A button cells as backup power for the digital memory to prevent loss of messages during power failure. Speak clearly into the microphone from 6 to 8 inches away and the display will count up. Press STOP when you have finished your message. The Answering System will play back your OGM and then the display should read A1. To Insert Sound Effects into Your OGM Press any of the three sound effects keys while recording your outgoing message to insert phrases into your message. Watch the display to keep track of your remaining time. PROBLEM SOLVING GUIDE No sound during ICM playback or call monitoring. Adjust the speaker volume control Cannot record an outgoing message ( OGM ). Make sure you press and hold the OGM button for 2 seconds until the message display counts up. Backup batteries were not installed or need replacing. Answering System takes calls on the wrong number of rings. Extension phones operating on the same line of your Answering System weaken the signal received by the system. This may cause your answering system to take longer to answer. [. . . ] Press the "SKIP" and "REPEAT" button once until you choose the 3rd digit. Press the "On/Off" button once to enter the 3rd digit Note: If no key is pressed within 8 seconds, the setup procedure will be aborted. Power Failure Security The memory of the system will be protected during an AC power failure if the 5x1. 5V or G13A button cells are installed. After power resumes, the system will return to its previous state. [. . . ]