User manual HASBRO FURREAL FRIENDS NEWBORN BABY CUBS

[. . . ] If you still do not interact with it, it will enter Sleep Mode after about a minute (see below). Sleep Mode When your toy puppy enters Sleep Mode, it lowers its head and starts to snore. To wake your toy puppy up again, pet its back. PLEASE NOTE: Only the front legs of your toy puppy are poseable. [. . . ] Your toy puppy's carrier has two straps that help keep your toy puppy in the carrier. Calm Mode If you press and hold the sensor on your toy puppy's back for about 3-5 seconds, it will sigh and enter Calm Mode. Then if you do not interact with your toy puppy within about 5-10 seconds, it will enter Sleep Mode (see below). TROUBLESHOOTING If your toy puppy does not respond properly, slide the power switch to OFF, then back to ON. 4 5 TO REPLACE BATTERIES Using the Phillips/cross head screwdriver (not included), loosen screw in battery compartment cover (screw stays attached to cover). Remove door and replace with 3 x 1. 5V "AAA" or LR03 size alkaline batteries. Replace cover and tighten screw. CAUTION: 1. Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by matching the + and ­ polarity markings. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries. Remove exhausted or dead batteries from the product. Remove batteries if product is not to be played with for a long time. Do not use detergent or stain removers on fur. Do not get wet; to remove stains, use only a slightly damp cloth on the fur. To prevent staining fur, wipe off dirt immediately. If toy gets wet, remove batteries and dry the fur; once fur is completely dry, replace batteries. Avoid spilling food or beverages on the toy. Do not throw or kick the toy, and do not push sharp objects through the speaker openings. Do not leave toy in direct sunlight; high temperatures will destroy the mechanism. FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]