User manual HASBRO GUARDIAN OF THE GRAVE

[. . . ] Confirm that the headphones make a “click” sound when you put them on the transmitter. When the headphones are correctly placed on the transmitter, the upper surface of the headphones becomes level with the transmitter. The CHG indicator turns off when charging is complete. Replacing the earpads The earpads are replaceable. [. . . ] ΍ Using the audio out (L/R) jacks of the A/V component L (white) Stereo mini plug Audio out (L/R) jacks Stereo system, Blu-ray Disc player, DVD player, etc. 4-429-926-11(1) ©2012 Sony Corporation Printed in China R (red) GUARDIAN OF THE GRAVE English Wireless Stereo Headphone System WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To reduce the risk of fire or electric shock, do not expose this apparatus to dripping or splashing, and do not place objects filled with liquids, such as vases, on the apparatus. Do not expose the batteries (battery pack or batteries installed) to excessive heat such as sunshine, fire or the like for a long time. To avoid electrical shock, do not open the cabinet. refer servicing to qualified personnel only. Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. As the main plug of AC power adaptor is used to disconnect the AC power adaptor from the mains, connect it to an easily accessible AC outlet. Should you notice an abnormality in it, disconnect it from the AC outlet immediately. Excessive sound pressure from earphones and headphones can cause hearing loss. € Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. € Change the radio frequency with the CHANNEL selector on the transmitter, then press the AUTO TUNING button on the right housing of the headphones. € Use the headphones near the transmitter, or change the position of the transmitter. If the power indicator is still off after charging, take the headphones to a Sony dealer. 0 W Operating temperature 5°C to 35°C (41°F to 95°F) RF stereo transmitter (TMR-RF985R) Distorted or intermittent sound (sometimes with noise) – Charge the headphones. If the power indicator is still off after charging, take the headphones to a Sony dealer. € Use the headphones near the transmitter, or change the position of the transmitter. € Do not place the transmitter on a metallic table. € If you connect the transmitter to an A/V component using the headphone jack, lower the volume level on the connected A/V component within the range where the sound is not distorted. € Change the radio frequency with the CHANNEL selector switch on the transmitter, then set to the same radio frequency with the AUTO TUNING button on the right housing of the headphones. Tips for volume setting – If you connect the transmitter to the headphone jack of the A/V component, set the volume of the A/V component as high as possible but not so high that the audio signal becomes distorted. € When watching videos, be careful not to raise the volume too high in quiet scenes. [. . . ] If you connect the transmitter to an A/V component using the headphone jack, raise the volume level on the connected A/V component within the range where the sound is not distorted. Included items RF stereo transmitter TMR-RF985R Wireless stereo headphones MDR-RF985R AC adaptor (12 V) (1) Connecting cable (stereo mini plug  pin plug × 2), 1 m (39 3/8 in) (1) Card warranty (1) Operating Instructions (this manual) (1) Design and specifications are subject to change without notice. After use Turn off the power of the headphones. About sending RF signals The transmitter starts sending RF signals automatically when it detects an audio signal from the connected component. [. . . ]