User manual HASBRO MARRY DATE OR DUMP

[. . . ] Changes to the specifications and features in this manual may be made by HASBRO without prior notice. No part of this manual may be reproduced, copied, translated, transmitted, or published in any form or by any means without HASBRO's prior written permission.  In order to assist in the use of this product, carefully read the User's Manual.  For product-related information, check on our website at: http://www. gigabyte. com Identifying Your Motherboard Revision The revision number on your motherboard looks like this: "REV: X. X. " For example, "REV: 1. 0" means the revision of the motherboard is 1. 0. [. . . ] Auto lets the BIOS automatically configure this setting. (Default: Auto) This item is present only when you install a CPU that supports this feature. - 27 - && C-state Pmin (Note) && Extreme Memory Profile (X. M. P. ) (Note) Allows the BIOS to read the SPD data on XMP memory module(s) to enhance memory performance when enabled. (Default) Profile1  Uses Profile 1 settings. Profile2 (Note) Uses Profile 2 settings.  Allows you to set the system memory multiplier. Auto sets memory multiplier according to memory SPD data. (Default: Auto) This value is automatically adjusted according to the BCLK/PCIe Clock Control and System Memory Multiplier settings. && System Memory Multiplier && Memory Frequency (MHz) `` Advanced Memory Settings && Extreme Memory Profile (X. M. P. ) (Note), System Memory Multiplier, Memory Frequency(Mhz) The settings above are synchronous to those under the same items on the Advanced Frequency Settings menu. Quick and Expert allows the memory timing settings below to be configurable. Options are: Auto (default), Quick, Expert. When using a non-AMP memory module or Extreme Memory Profile (X. M. P. ) is set to Disabled, this item will display as 1. 50V. You can adjust the fan speed with EasyTune based on your system requirements. (Default) Silent  Allows the CPU fan to run at slow speeds. Manual Allows you to control the CPU fan speed under the Slope PWM item.  Disabled Allows the CPU fan to run at full speeds.  Allows you to control the CPU fan speed. This item is configurable only when CPU Fan Speed Control is set to Manual. Options are: 0. 75 PWM value /oC ~ 2. 50 PWM value /oC. Allows you to determine whether to enable the system fan speed control function and adjust the fan speed. Normal   Allows the system fan to run at different speeds according to the system temperature. You can adjust the fan speed with EasyTune based on your system requirements. (Default) Silent  Allows the system fan to run at slow speeds. [. . . ] To copy the RAID/AHCI driver for Windows XP, copy all files in the \BootDrv\Hxp folder in the motherboard driver disk to your floppy disk. To install Windows 7/Vista, you also need to install the SATA RAID/AHCI driver during the OS installation. To copy the RAID/AHCI driver for Windows 7, copy the whole Hw7 folder under the BootDrv folder in the motherboard driver disk to a USB flash drive. Installing the SATA RAID/AHCI Driver and Operating System A. Installing Windows XP Restart your system to boot from the Windows XP setup disk and press <F6> as soon as you see the message "Press F6 if you need to install a 3rd party SCSI or RAID driver. " Insert the floppy disk containing the SATA RAID/AHCI driver. [. . . ]