User manual HASBRO MICKEY GO ALONG GAMES IN ENGLISH AND SPANISH

[. . . ] € Check the plug-in connectors on the hoses for firm seating. € Take steps to ensure that the fluid being pumped cannot come into contact with the electric drill during pumping. Should it nonetheless occur, immediately remove the power plug. € Avoid the intake of coarse dirt, otherwise the pump could be damaged. [. . . ] µ Screw the short drive shaft e onto the drive shaft w of the pump q. µ Insert the electric drill u with the chuck into the mounting y. µ Now push the pump q onto the mounting y so that the drive shaft e projects into the chuck and the pins of the mounting y are located in the reception holes on the pump q. µ Now tighten the chuck with the chuck key through the recess i so firmly that the pump q can no longer release itself from the mounting y. µ Tighten the cross-headed screw on the mounting y firmly, so that the drill u cannot jolt around. µ Attach the suction hose to the connection o and the pressure hose to the connection a. Pay heed to the direction of flow detailed on the pump q. When using a quick-release chuck and the short drive shaft e. µ Secure the short drive shaft e into the chuck. µ Insert the electric drill u, with the pre-assembled drive shaft e in the chuck, into the mounting y. µ Securely tighten the cross-head screw on the mounting y so that the drill u is being firmly held. µ Remove the drive shaft r from the chuck. If the pump q does not start to suck up within 12 seconds, turn the drill u off immediately to avoid seizure. For this same reason, do not allow the pump q to commence suction if the pressure hose on the discharge side is closed. µ Place the open end of the suction hose into the liquid that is to be pumped. The suction hose may not be longer than 3 m. Ensure that the suction hose does not pull in air. If the pump q does not commence suction, fill the hose with some water and then lift it so that the liquid runs before the pump. µ Allow the drill u, now the pump q, to start-up – but not without supervision, so that you can react quickly in the event of danger. Absolutely ensure that the electric drill u is rotating to the right, as with normal drilling. Should the rotation speed of the electric drill u be adjustable, you can use this to regulate the discharge flow. Turn the drill off immediately after the container is empty. [. . . ] 2012 12:08 Uhr Seite 40 Warranty and Service The warranty for this appliance is for 3 years from the date of purchase. The appliance has been manufactured with care and meticulously examined before delivery. Please retain your receipt as proof of purchase. In the event of a warranty claim, please make contact by telephone with our Service Department. [. . . ]