User manual HASBRO MILLE BORNES

[. . . ] ? 3 4 5 PLEASE NOTE: Please note: u The mains adapter must always be connected, as the phone will not operate without a mains connection. u Only use the mains adapter and phone cord supplied. [. . . ] u The LED display should light up at the base station. If not, please ensure the power lead is fully inserted. 8 7 6 For a dial tone press the call button c for approx. Message Indication Key f on handset will flash to indicate one or all of the following events: u missed calls (if caller ID is enabled for your line numbers will be shown) u new messages on the answering machine (also indicated by flashing message counter on base station) u new Text messages (SMS) received If you have problems setting up or operation this product please call Connecting the charging cradle (if included) 1 one Gigaset C610A base 2 one mains adapter 3 one Gigaset C610H handset 4 one phone cord 5 two batteries 6 one battery cover 7 one belt clip 8 one user guide plus one quick start guide Connect the flat plug from the mains adapter 1. Plug the mains adapter into the plug socket 2. GIGASET HELPLINE 0845 3670812 1 2 Quick Start Guide GIGASET HELPLINE: 0845 3670812 If you have purchased a model with multiple handsets the package should contain two batteries, a battery cover, a belt clip and a charging cradle 9 with mains adapter J for each additional handset. 9 J If you need to disconnect the plug from the charging cradle, press the release button 3 and disconnect the plug 4. 4 Issued by Gigaset Communications GmbH Frankenstr. D-46395 Bocholt Gigaset Communications GmbH 2011 All rights reserved. www. gigaset. com A31008-M2325-L101-1-7643 3 Preparing the handset Insert the batteries the right way round. Please refer to Chapter ?Operating the answer machine of the Gigaset C610A base station?47). Saved The display shows Saved. You will hear a confirmation tone and the handset will automatically return to idle status. Initial charging and discharging of the batteries The correct charge level can only be displayed if the batteries are first fully charged and discharged. Display in idle status u Reception signal between the base and handset: i V Q: The display is not clear. A: The display is protected by a plastic film, please make sure you have removed the protective film. A: If your handset is not registered, please refer to Chapter ?Registering handsets?55) to instructions how to register handsets manually. Place the handset in the base/charging cradle for 10 hours. Press down on the control key to switch to the time input field. 10 h Then remove the handset from the base/charging cradle and do not replace it until the batteries are fully discharged. Date/Time Date: 14. 10. 2009 Time: 00:00 Enter the hours and minutes as four digit numbers via the keypad, e. g. [. . . ] Change the input position with the control key if necessary. ?no reception: | flashes Green: Eco Mode activated u : answering machine is activated u Battery charge status: ? [. . . ]