User manual HASBRO MISSING MASTERPIECE

[. . . ] — For your safety and protection, the telephone must not be used in bath or shower rooms (wet locations). — Never expose the telephone to sources of heat, direct sunlight or other electrical devices. — Protect your telephone from moisture, dust, corrosive liquids and vapours. ◆ Never open up the telephone yourself. [. . . ] then it is automatically switched to pulse dialling. The telephone is reset to the original dialling mode by hanging up the handset. Recall key (on a PABX) During an external call, you can make a recall or divert the call. The subsequent procedure depends on your PABX. By default, the Recall key is preset to a flash time (interruption time) of 90 ms for use of new features on public telephone systems. With a connection to a PABX, it may be necessary to change the flash time (e. To do this, please refer to the operating instructions for your PABX. f ¢ Phone Setup ¢ Exchange Code o A/ C o >. > B If no external line prefix has been set in a storage location, "-" flashes in the display. If several external line prefixes have been saved, they will be displayed side by side; the current external line prefix for editing flashes. C to toggle between the external line prefixes displayed to edit them as follows: To enter an external line prefix: Enter a one- to three-digit code. Deleting the prefix: You can delete the emergency number one character at a time using the R-key Press the OK key. Activating/deactivating the display of incoming phone numbers during a call The CLIP display of incoming phone numbers during a call can be activated or deactivated. Viewing caller histories and dialling phone numbers If there are entries in the calls list that have you have not flashes in the display. The number of list yet seen, entries which have not been viewed yet is displayed. 11 9 GB Deactivating/activating the symbol display for network services Displaying the symbols can be activated or deactivated as needed (default setting: display deactivated). Activating/deactivating the call waiting tone The advisory tone that is heard when a call is received during another call can be activated or deactivated. Activating/deactivating anonymous calling If you do not want your phone number to be displayed for the other party, you can set this on your telephone for the immediately following call: "You have a message" display Different network providers offer services for saving messages (e. If one or more newly received messages have been stored with the network provider, it may inform you via your telephone. In the display, this notification from the network provider is displayed with the ‹ symbol and the phone number. You can now dial the corresponding phone number in order to check the stored messages. O Enter the number for the the anonymous call. [. . . ] The CLIP evaluation of the number of the SMS centre takes place in your telephone. — Depending on your PABX, you may have to add the access code (external line prefix) before the number of the SMS centre. You can store the access code in your telephone. By sending an SMS to your own phone number, once with and once without the access code. [. . . ]