User manual HASBRO MONOPOLY 60TH ANNIVERSARY EDITION

[. . . ] u If you give your telephone to someone else, make sure you also give them the operating manual. Your Gigaset DA510 has a permanent memory, so you may want to delete any stored numbers before passing it on. Setting up the telephone for use Recommended installation of telephone: u Do not expose the telephone to direct sunlight or other sources of heat. u Operate at temperatures of between +5°C and +40°C. u Maintain a distance of at least one metre between the telephone and radio equipment, e. g. [. . . ] u If the number entered is longer than 32 digits, only the first 32 digits are stored. £ Dialling pauses One or more dialling pauses can be entered using I (not at 1st digit). Pauses are transferred to the memory and are necessary for certain extension systems (e. g. The length of the pause can be set to 1, 3 or 6 seconds ( page 9). £ Gigaset DA510 /IM1 en / A30054-M6530-R101-3-7W19 / DA510_en. fm / 17. 01. 2012 5 en Adjusting the telephone Setting the handset volume The volume can be set to three levels. Setting the ringer melody Lift the handset, press the set key. O Press one of the number keys to select a melody. K & Press the set key, hang up the handset. You can also change the ringer melody during ringing by using the number keys (0 . . . Note: The length of the playable ring tone depends on the duration of the signal voltage in your telephone network. This can differ depending on the country and the telephone network. If the ringer melody you choose is shortened or truncated, please choose a different one if necessary. cK G During a call Adjust the volume with the loud/quiet key. In idle mode cKO . . . 3 K& Lift the handset, press the set key, press the number 9 key. Press the set key, hang up the handset. Mute Depending on the setting of the mute function ( page 9), you can deactivate the telephone's microphone and/or earpiece during a call. /2/3 Press a number key 1, 2 or 3 under which the number you want to unblock is stored. K & Press the set key, hang up the handset. Changing the dialling mode cK # /2 K& Lift the handset, press the set key. Press the set key, hang up the handset. Changing the flash time You can change the flash time if the dialling mode is set to tone dialling (see above). c K Lift the handset, press the set key. Operation on a PABX Special functions/Recall key During an external call, you can make an enquiry or forward the call. The subsequent procedure depends on your PABX. To set the recall key, the telephone’s flash time must be set consistent with your PABX. Please refer to the operating instructions for your PABX. O5 Q . . . 5 K& Press the number keys 1, 9 and 5. Press the number key for the flash time you want (for possible valpage 9). ues, Press the set key, hang up the handset. £ Changing the dialling mode/ flash time The telephone supports the following dialling modes: u Tone dialling u Pulse dialling Depending on your PABX, you may need to change your phone’s dialling mode or the flash time. Normally the phone is preset to the required settings for your country. Temporary tone dialling switching in "Pulse" position To use functions that require tone dialling (e. g. [. . . ] Deletes the contents of all programmable direct dial keys Deletes all dialling prefixes Restores any programmable direct dial keys preset by the network provider (as appropriate) slow flashing fast flashing deactivated 1. 5 : 1 2:1 85 / 85 ms 85 / 110 ms 85 / 140 ms 110 / 110 ms 70 / 70 ms 90 ms 120 ms 270 ms 375 ms 600 ms 100 ms Sets or deactivates LED call indication 1 32 1 1 91 92 Sets the pulse ratio for pulse dialling Sets the signal time / signal pause for tone dialling 1 95 Sets the flash time for tone dialling 5 6 8 0–4 0–9 0 1 2 1–3 1 2 Sets the ringer volume, 5 levels, 0: ringer off Sets the ringer melody, 10 melodies Deactivates the keylock Activates the keylock Temporarily deactivates the keylock Sets the volume on the handset, 3 levels Tone dialling Pulse dialling Sets the dialling mode 9 # Gigaset DA510 /IM1 en / A30054-M6530-R101-3-7W19 / DA510_en. fm / 17. 01. 2012 10 en Appendix Care Wipe the unit with a damp cloth or an antistatic cloth. Do not use solvents or microfibre cloths. The dialling tone is audible but the telephone will not dial: The connection is OK. The other party cannot hear you: Mute activated? [. . . ]