User manual HASBRO OPERATION SHREK SPANISH

[. . . ] 8 Switching off water softening system . 9 Switching off rinse aid refill indicator . 16 Express Wash/ Speed Perfect (VarioSpeed) . 16 en Safety instructions Before you switch ON the appliance Please read the operating and installation instructions carefully. [. . . ] There is a slight increase in the energy consumption. 16 en nargoTiep m Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. – Press button @ + until the digital display )" jumps to : . – Press @ + or – button until the displayed time corresponds with your requirements. – Press START button P, timer programming is activated. – To delete timer programming, press the @ + or – button until )" : is indicated on the digital display. You can change your programme selection at any time until the programme starts. To change the setting: – Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). The set value is saved. Switching off the appliance Short time after the end of the programme: – Switch off ON/OFF switch (. – Turn off the tap (not applicable if AquaStop fitted). – Remove the utensils when they have cooled down. ã=Warning End of programme The programme has ended when the value : is indicated on the numerical display )". At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Switching off automatically after the end of the programme * myftelargeodfthnpar tncmta lfaSihgouw Interrupting the programme – Switch off ON/OFF switch (. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. – Regularly clean door seal with a damp cloth. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. ã=Warning Never use other chlorinated household detergents!Health hazard! Special salt and rinse aid – Check the refill indicators ` and h. If required, refill salt and/or rinse aid. 18 en Filters The filters 1R keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. [. . . ] – The socket must be near the appliance and freely accessible following installation. If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions. – The connection may be modified by technicians only. – A power cord extension may be purchased from customer service only. [. . . ]