User manual HASBRO PAPERBOY

[. . . ] If you have any questions ć particularly concerning installation and connection of the appliance ć please do not hesiĆ tate to contact our customer service. Further information and a selection of our products can be found on our home page. Please read these operating instructions as well as the installation instructions and all information enĆ closed with the appliance and follow accordingly. Retain all documents for subsequent use or for the next owner. [. . . ] S Press the glass against the dispenser pad. The water stops running when the glass is removed from the pad. tip: The water from the water dispenser is cooled to a palatable temperature. If you would like the water colder, place ice cubes in the glass before dispensing the water. Automatic ice and water dispenser The following can be dispensed as required: - cooled water - ice cubes - crushed ice Warning!Do not use fragile receptacles for dispensing water or ice ć risk of injury from broken glass!Keep fingers clear of the discharge opening. Note: The ice and water dispenser will not function unless the appliance is connected to the power supply. Dispensing ice S Press the button until the symbol for ice cubes or crushed ice lights up. Drinking water quality All materials used in the drinks disĆ penser are odourless and tasteless. If the water has an aftertaste, this may be caused by: - Mineral and chlorine content of the drinking water. S Remove the ice cube container, empty and reĆinsert. Ensure that the ice cube container engages with the support. Switching on the ice cube maker again: S Press Ice maker" lock button. Inserting the ice cube container S Push the ice cube container all the way back onto the supports until it locks into position. Warning In places where the water quality is suspect or unknown, do not use the appliance without adequate disinfection before or after filtering. A new filter can be obtained from afterĆ sales service. S Carefully turn the filter 90º antiĆclockĆ wise, and pull it out. S Remove the new filter from its packĆ aging and remove the protective cap. S Insert the new filter into the holder, and carefully turn it 90º clockwise. Change the filter at least every 6 months, and, at the latest, when Filter change required" appears in the display. S If the container cannot be pushed all the way back, twist the screw conveyor in the container. [. . . ] Caution: Should it be necessary to remove the doors, this must only be carried out by our afterĆsales service. Your local afterĆ sales service will quote you a price for removing the doors. Connection S Connect the line to the solenoid valve. S Using the enclosed clips, attach the connecting line to the rear panel of the appliance and to the room wall. [. . . ]