User manual HASBRO PENNY CANDY

[. . . ] Please ask your dealer or inquire at your local authority about current means of disposal. 24 Prior to installation Exhaust-air mode 237, 4 40 247, 2 1058, 5 - 1486, 5 Ø 150 Ø 150 547-975 137-565 900 The exhaust air is discharged upwards through a ventilation shaft or directly through the outside wall into the open. For operating in exhaust-air mode, a oneway flap should be mounted inside the wall ventilation box. If no one-way flap was enclosed with the hood, it can be obtained from a specialist retailer. [. . . ] If no one-way flap was enclosed with the hood, it can be obtained from a specialist retailer. Installing the one-way flap: ❑ Snap the one-way flap into the air pipe. The two lightly sprung flaps must be able to move upwards. If the exhaust air is going to be discharged into the open, a telescopic wall box should be fitted into the outside wall. ❑ For optimum extractor hood efficiency: ❑ Short , smooth air exhaust pipe.  As few bends in the pipe as possible.  Diameter of pipe to be as large as possible and no tight bends in pipe. If long, rough exhaust-air pipes, many pipe bends or smaller pipe diameters are used, the air extraction rate will no longer be at an optimum level and there will be an increase in noise.  Round pipes: We recommend Internal diameter: 120 mm ❑ Flat ducts must have an internal cross section that equates to that of round pipes.  For exhaust-air mode, ensure that there is an adequate supply of fresh air. Fasten the support bracket to the wall with 2 5x45mm screws (4). 4 G 1 3 3 3 2 • Open the panel and remove the grease filters (see relevant paragraph). 27 Installation • Hang the hood (5), regulate the position (6-7) and fasten it securely with one screw and washer(8). € Only for filtering version without chimney installation: remove the fume non-return valve from the flange (9a). 7 Ø M5 x 18 6 9a 5 5 • Install the flange (9b) with 2 screws. 8 Ø 3, 5x9, 5 9b • Carry out electrical connections, but leave the hood disconnected from the general electrical main panel. 28 Installation • For exhaust-air mode only: Carry out the connection of one tube (10A – tube and ties for fastening not included, they need to be bought) for the fume discharge to the connection ring placed on top of the extractor motor unit. The other end of the tube should be connected to a fume expulsion device towards the outside, in case the hood is used in extractor version. Note: a multi-fitting for pipes of different diameters is supplied with the hood (see drawing below). € For chimney installation only: In case you want to use the hood in filtering version, fasten the deflector F to the support bracket, and connect the other side of the tube to the connection ring placed on the deflector (10F). [. . . ] Note: a multi-fitting for pipes of different diameters is supplied with the hood (see drawing below). € For chimney installation only: In case you want to use the hood in filtering version, fasten the deflector F to the support bracket, and connect the other side of the tube to the connection ring placed on the deflector (10F). Ø 2, 9 x 6, 5mm G F 10F Ø 120-125 Ø 150 10A Use a small flat-tip screwdriver to bend upwards (perfectly vertical) the three tangs situated on the upper side of the hood at the sides of its exhaust hole (11). They will be used as a stop for the chimney. [. . . ]