User manual HASBRO PLAY-DOH DR. DRILL 39N FILL ELECTRONIC

[. . . ] J Any change to the appliance's interior, including changing the power cable, must be performed by the Technical Assistance Service. Preparing the kitchen units - Figure 1/2/3/4 J The worktop should be flat and horizontal. The aperture should be cut before the appliance is installed. [. . . ] The aperture should be cut before the appliance is installed. Remove any shavings, as these can affect the operation of the electrical components. When the cutting has been completed, the unit's stability should be checked again. J Surfaces which have been cut should be sealed so that they are heat resistant and so that they do not swell when moist. J The kitchen units to be fitted must resist temperatures of up to 90ºC. J The gap between the aperture and the side wall must be at least: 40 mm. It is not recommended that the hob be placed between two side walls but, if this is the case, a gap of at least 200 mm should also be left on one side. J The worktop where the hob is installed should be: 30 mm thick, if it is installed above an oven, 20 mm thick, if it is installed without an oven or above a drawer. J If a wooden panel is installed as an intermediate support, this should be 5 mm thick. The following requirements must also be taken into account: - allow a gap of 65 mm between the wooden panel and the top section of the hob. - the aperture cut in the back of the panel (figure 2) must be sufficiently deep to enable the hob cable to be fed through it (figure 3). The wooden panel must be as airtight as possible, to separate the drawer from the area in which the hob air is circulated. To ensure this is the case, the dimensions of the panel must be adjusted to fit the measurements of the kitchen unit housing in which the hob will be installed. Installing and connecting the hob Ć Figure 5 J See the rating plate for the voltage. J Connect according to the connection diagram only. J The earth wire (green and yellow) should be connected first and disconnected last. [. . . ] J Connect according to the connection diagram only. J The earth wire (green and yellow) should be connected first and disconnected last. It should also be longer than the others, so that even if the hob is moving the other wires can be disconnected before the earth wire. [. . . ]