User manual HASBRO PLAY-DOH GEORGE FOREMAN GRILL

[. . . ] Appliances with electrical supply must be earthed. Do not tamper with the appliance's interior. If necessary, call our Technical Assistance Service. Make an appropriate size cut in the work surface. [. . . ] Check that the voltage and power of the appliance are compatible with the electrical installation. The hobs are supplied with a power cable with or without a wall socket plug. Provide an omnipolar cut-off switch with a minimum contact separation of 3 mm (except for plug connections, if the user has access to it). Appliances with plugs must only be connected to sockets that have earth wires correctly installed. This appliance is type “Y”: the supply cable can only be changed by the Technical Assistance Service and not the user. The cable type and minimum cross-section must be respected. Changing the gas type Installation of appliance The clips and the adhesive seal (underside of the hob) are factoryfitted: do not under any circumstances remove them. The seal ensures that the entire work surface will be watertight, and prevents water seepage. In order to fit the appliance into the kitchen unit, first place the hob in the correct position then loosen each of the clips so that they all turn freely (it is not necessary to completely undo them). Press the sides of the hob until it is supported around its entire perimeter. Unscrew the clips and proceed in the reverse order to installation. 7): The glass panel and frame are fixed to the rest of the hob using a clip mounting system. The following steps must be taken to remove the glass panel and frame: - Remove all the burner covers and pan supports. - Release the front clip fixing the appliance to the kitchen unit by removing the screw. - Loosen the screws on the burners, fig. 7c-7d, and remove the control knobs from their respective housings. Use the disassembly lever 483196 available from our Technical Assistance Service. To release the front clips, apply the lever in the area shown in figures 8 according to the hob model. Never use the lever on glass edges which have no trim or frame!- To release the rear clips, carefully raise the entire glass panel and frame, as in fig. 9a): - Loosen the clamp screw to release the bushing by moving it backwards to access the main nozzle easily. - Remove the outer flame nozzle by turning it towards the left. [. . . ] Refit all the components, proceeding in the reverse order to removal. 1-2) Adjustment of the taps Set the control knobs to minimum. Simply press on this seal with the tip of a screwdriver to allow access to the tap adjusting screw. Never remove the valve reinforcing ring. [. . . ]