User manual HASBRO PLAY-DOH PIRATE ADVENTURE

[. . . ] The manufacturer accepts no responsibility for any malfunction or damage which is caused by incorrect electrical installation. j The fuse on devices B or C is essential. J If the appliance is not fitted with an accessible plug, disconnecting means must be incorporated in the fixed installation, in accordance with the installation regulations. [. . . ] J Induction hobs should only be installed on forced ventilation ovens of the same specification. Refrigerators, dishwashers, unventilated ovens or washing machines must not be installed under the hob. J If the hob is installed above a drawer, it is recommended to use an intermediate support, as metal objects stored in the drawer could reach high temperatures as a result of the circulating air coming from the hob's ventilation system. A strip of wood can be used as an intermediate support or an appropriate accessory can be obtained from our After-Sales Service. The reference code for this accessory is 680502. J Any change to the appliance's interior, including changing the power cable, must be performed by the Technical Assistance Service. When the cutting has been completed, the unit's stability should be checked again. J Surfaces which have been cut should be sealed so that they are heat resistant and so that they do not swell when moist. Installing and connecting the hob Ć Figure 6 J See the rating plate for the voltage. J Connect according to the connection diagram only. J The earth wire (green and yellow) should be connected first and disconnected last. It should also be longer than the others, so that even if the hob is moving the other wires can be disconnected before the earth wire. J Do not trap the lead during installation and do not guide it over sharp edges. J The hob and the worktop should not be sealed with silicone, as the hob itself has a seal which serves this function. Removing the hob Disconnect the cooker from the power supply. Fitting the securing rails Ć Figure 5 Notes: Use the lower bolt holes on tiled work surfaces. [. . . ] Fitting the securing rails Ć Figure 5 Notes: Use the lower bolt holes on tiled work surfaces. For granite or marble work surfaces: Place pins or bushes for the securing screws or stick on rails. Do this using temperatureĆresistant glue suitable for fixing metal onto stone. [. . . ]