User manual HASBRO POKEMON MEMORY GAME

[. . . ] The iron begins to smoke when switched on. Flashing lamp on top of handle (*) During first use: Certain components on the appliance have been lightly greased at the factory and may produce a little smoke when initially heated. This is completely normal and will stop after a short while. Move the iron gently fromside to side to restart it. [. . . ] It must be checked by an authorized Technical Service Centre before it can be used again. · Do not allow the power cable to come into contact with the soleplate when it is hot. · In order to avoid that, under unfavourable mains conditions, phenomena like transient voltage drops or lighting fluctuations can happen, it is recommended that the iron is connected to a power supply system with a maximum impedance of 0. 27 . If necessary, the user can ask the public power supply company for the system impedance at the interface point. · This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capacities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. · Keep the appliance out of children's reach. · Children should be supervised to ensure that they do not play with the appliance. · Remove the plug from the socket before filling the appliance with water or before pouring out the remaining water after use. · The appliance must be used and placed on a stable surface. · When placed on its stand, make sure that the surface on which the stand is placed is stable. · The iron must not be left unattended while it is connected to the supply mains. If the tap water in your district is very hard, mix tap water with distilled water 1:2. You can inquire about the water hardness with your local water supplier To prevent spillage of water out of the appliance in vertical position, never fill beyond the «max» water level mark! 2. If you are unsure what type of material the garment is made from, start ironing on the lowest temperature setting and increase accordingly. If the garment is made from mixed fabrics, set the temperature for the most delicate material. For silk, woollen or synthetic materials iron the reverse side of the fabric to prevent shiny patches. Avoid using the spray function to prevent stains. Sort your garments based on their care labels, always starting with clothes that have to be ironed at the lowest temperature. The pilot lamp (K) will stay lit while the iron is heating up and go out once the selected temperature has been reached. Wait a few seconds after the lamp goes out before you start ironing. Once the iron is ready, you can continue to iron even if the pilot lamp comes on again. If your iron has auto shut-off and the lamp on the top of the handle (N) is flashing, the auto shut-off has activated. [. . . ] Select an appropriate temperature for the type of material being ironed. Spray This can be used to remove stubborn wrinkles. Do not use the spray function with silk as staining may occur. Make sure that there is water in the tank (F). [. . . ]