User manual HASBRO PONY IN MY POCKET 1 COLLECTION

[. . . ] The complete installation set and replacement filters can be obtained from specialist outlets. The corresponding accessory numbers can be found at the end of these operating instructions.  The extractor-hood fan extracts the kitchen vapours which are purified in the grease filter and activated carbon filter and then conveyed back into the kitchen.  The grease filter absorbs the grease particles in the kitchen vapours. [. . . ] T3 Speed increase Press T3 button and the hood sets from OFF to speed 1. Press the button (hood ON) to increase the speed of the motor from 1 to 4 (intensive). The respective LED goes on for each speed. Speed 1 LED 1 Speed 2 LED 2 Speed 3 LED 3 Intensive speed LED 4 (flashing) The intensive speed is timed. Standard timing is 5’, at the end of which the hood sets to speed 2. 30 Grease filter signal After 40 hours of operation LED 1 flashes. When such signal appears the grease filter installed needs to be washed. To reset the signal, keep T4 button pressed for 5”. The hood gives out a “BEEP” and LED 1 stops flashing. charcoal filter signal After 160 hours of operation LED 2 flashes. When such signal appears the charcoal filter installed must be replaced. Important: By cleaning the metal grease filters at appropriate intervals, the possibility of them catching fire as a result of a build-up of heat such as occurs when deep-fat frying or roasting is taking place, is reduced. Cleaning the metal grease filters: ❑ These must be cleaned once a month (or when the filter saturation indication system – if envisaged on the model in possession – indicates this necessity). ❑ The filters can be cleaned in a dishwasher. It is however possible that they will become slightly discoloured.  The filter must be placed loosely, and NOT wedged, in the dishwasher. Important: Metal filters that are saturated with grease should not be washed together with other dishes etc.  When cleaning the filters by hand, soak them in hot soapy water first of all. Then brush the filters clean, rinse them thoroughly and leave the water to drain off. Cleaning: The panel must be cleaned as often as the grease filter, wash by hand with nonabrasive detergents. Use the drainpipes placed near the corners at the back to make the water left inside flow. Montage: Proceed in the reverse direction for dismantling. [. . . ] Replace the mattress every 3 years and when the cloth is damaged.  The activated carbon filters are available from specialist outlets (see Optional accessories). The appliance is then guaranteed to function perfectly. Disposal of old activated carbon filters: ❑ Activated carbon filters do NOT contain any harmful substances. [. . . ]