User manual HASBRO PROBEFRENCH

[. . . ] 22 11:00:11 AM FOR CUSTOMER ASSISTANCE (the United States) To aid in answering questions if you call for service or for reporting loss or theft, please record below the model and serial number located on the back side of the unit. MODEL NUMBER SERIAL NUMBER DATE OF PURCHASE Dealer Name Address City State Zip Telephone TO PHONE: Dial 1-800-BE-HASBRO (237-4277) for: SERVICE (for your nearest Sharp Authorized Servicer) PARTS (for your Authorized Parts Distributor) ACCESSORIES ADDITIONAL CUSTOMER INFORMATION TO WRITE: For service problems, warranty information, missing items and other assistance: Sharp Electronics Corporation Customer Assistance Center 1300 Naperville Drive Romeoville, IL 60446-1091 TO ACCESS THE INTERNET: www. Com Please provide the following information when you write or call: model number, serial number, date of purchase, your complete mailing address (including zip code), your daytime telephone number (including area code) and description of the problem. USERS HASBRO ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the “Product”), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. [. . . ] 9" (1800mm) Use the window panel, the adjustment panel and the extension panel. (1) Open the window sash and place the window panel on the window frame. (2) Slide the adjustment and extension panels to fit the window frame height. (3) Secure the window panel to the window frame with 4 screws. 9" foam seal B proper 5 Cut theand attach themto the window length to the panel. Securely against the Foam seal B (adhesive type) 7 Attach the bracket with a screw. (Recommended) Please lay a tabular material underneath the window panel in case you could not attach the rain guard or the window adapter properly due to the deep window sill. 22 11:00:14 AM INSTALLATION AND REMOVAL OF EXHAUST HOSE Installation of the exhaust hose 1 Attach the window adapter to the exhaust hose. Extend one end of the exhaust hose and insert it into the window adapter, and turn it (approx. Window adapter Extend Exhaust hose 2 Attach the exhaust hose to the unit. Exhaust hose Insert the two projections into the two holes on the unit, and firmly attach them to each other until they click. The unit generates a beep when it receives the signal. € Make sure nothing, such as curtains, blocks the signal receiver window. € The signal effective distance is 23 feet (7 m). CAUTION: • Do not expose the receiver window to direct sunlight. This may adversely affect its operation. € Use of certain fluorescent lamp in the same room may interfere with transmission of the signal. € Do not leave the remote control in direct sunlight or near a heater. Protect the remote control from moisture and shock. ENGLISH To prevent the remote control from being misplaced, hook it to the unit when not in use. When attached, to remove the remote control from the unit, lift the remote control up slightly and pull it out. 22 11:00:15 AM USE FOR AIR CONDITIONER Use when the unit operates with the cool, dehumidification, fan or ventilation mode. [. . . ] € Did you restart the unit within 3 minutes of a power failure?If the power was off for less than 3 minutes when, you restarted the unit, a protective device may cause the compressor to shut off, preventing cooling for about 5 minutes. • Are the AIR CON , TIMER and MAXIMUM lamps blinking?Cooling does not take place in these modes. [. . . ]