User manual HASBRO PUZZ 3D MONOPOLY

[. . . ] The energy efficiency of this ENERGY STAR qualified model is measured based on a ratio between the model’ s CADR for Dust and the electrical energy it consumes, or CADR/Watt. 14 10:34:53 AM ESPAÑOL FRANÇAIS ENGLISH Please read before operating your new Air Purifier The air purifier draws in room air from the air intake, passes the air through a PreFilter, a Washable Deodorizing filter and a True HEPA filter inside of the unit, then discharges the air through the air outlet. 3 microns that pass through the filter and also helps absorb odors. The Washable Deodorizing filter gradually absorbs odors as they pass through the filter. [. . . ] Depending on the size and humidity of the room, humidity may not reach 45 - 55 %. in such cases , it is recommended that CLEAN AIR & HUMIDIFY/MAX MODE be used. Temperature 64 and below 64-75 75 and above Humidity 55% 50% 45% CLEAN AIR MODE Use the Clean Air Mode when additional humidity is not required. 1 Press the CLEAN AIR MODE Button on the display. € If the power cord was not unplugged between uses, the unit will automatically re-start at the previously selected settings. BUTTON 2 Press the FAN SPEED E-13) to select the desired fan speed. By continuously discharging strong airflow cycles, the unit effectively removes airborne dust, pollen, mold and allergens from the air as they are drawn through the filter system. Water must be in the Water Tank when this mode is selected. The unit humidifies when there’s water in the Water Tank, and it operates without humidifying when there is no water in it. Button on the display to select this When the operation finishes, the unit will return to the prior operation. Press the FAN SPEED Button to select the preferred fan settings. With the unit OFF, press the Lights Control button for 3 seconds to turn the audible signal ON. Cancellation To cancel the audible signal, with the unit OFF, press the Lights Control button again more than 3 seconds. ADJUSTMENT OF SENSOR DETECTION SENSITIVITY Set to ‘low” if the DUST MONITOR is constantly red to reduce sensitivity, and set to ‘high’ if the DUST MONITOR is constantly green to increase sensitivity. 1 With the unit OFF, press the Fan Speed Button for 3 seconds. The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The factory setting is Standard, indicated by the MED light. 2 Press the Fan Speed Button to set the desired sensor sensitivity. Refer to the diagram on the right to select the desired sensor sensitivity level. Fan Speed Indicator Light Sensor Detection sensitivity 3 Note that if the Power OFF Button is not pushed within 8 seconds of adjusting sensor sensitivity, the setting will be saved automatically. The sensor sensitivity setting will be saved even if the unit is unplugged. 14 10:35:10 AM CARE AND MAINTENANCE To maintain optimum performance of this air purifier, please clean the unit including the sensor opening and filters periodically. [. . . ] gently clean the dust sensors (See E-15). € Clicking or ticking sounds may be audible when the unit is generating ions. € Check to see if the filters are heavily soiled. This is normal and is a result of the Plasmacluster Ions refreshing the air. [. . . ]