User manual HASBRO SCOOTER

[. . . ] Pass them on to possible new owners of the appliance. Electrical connections After the appliance has been transported, carefully place it vertically and wait at least 3 hours before connecting it to the electricity mains. Before inserting the plug into the electrical socket ensure the following: • The appliance is earthed and the plug is compliant with the law. • The socket can withstand the maximum power of the appliance, which is indicated on the data plate located on the bottom left side of the fridge (e. [. . . ] Open the humidity regulator (position B) if you want to store food in a less humid environment, or close it (position A) to store food in a more humid environment. GB Chiller system No Frost It is recognisable by aeration cells located on the back walls of the compartments. The No Frost system circulates cold air continuously to collect humidity and prevent ice and frost formation. The system maintains an optimal humidity level in the compartment, preserving the original quality of the food, preventing the food from sticking together and making defrosting a thing of the past. Do not block the aeration cells by placing food or containers in direct contact with the refrigerating back panel. A B 5 GB Using the freezer to its full potential • Use the FREEZER OPERATION knob to adjust the temperature (see Description). • Do not re-freeze food that is defrosting or that has already been defrosted. These foods must be cooked and eaten (within 24 hours). • Fresh food that needs to be frozen must not come into contact with food that has already been defrosted. • Do not place glass bottles which contain liquids, and which are corked or hermetically sealed in the freezer because they could break. • The maximum quantity of food that may be frozen daily is indicated on the plate containing the technical properties located on the bottom left side of the refrigerator compartment (for example: Kg/24h: 4). The appliance must be switched off and the plug must be pulled out before cleaning the appliance. • During the cleaning of the slide rails for the drawers in the freezer compartment, it may happen that the automatic drawer closure mechanism is deactivated. To reactivate it, simply close the drawer a little more forcefully than is usually necessary. Optimization Energy Saving function The “Optimization Energy Saving” function may be activated in order to optimise energy consumption while maintaining the cooling performance of the product. This function maximises the energy saved. It is activated by setting the knobs to “I CARE”, then pressing and holding the Super Freeze button for at least 3 seconds; the Super Freeze indicator light will begin to flash, signalling the activation of this function. The Optimization Energy Saving function may also be deactivated by pressing the Super Freeze button again. The corresponding indicator light will stop flashing, thereby signalling that the original operating conditions have been restored. In humid environments, when the Optimization Energy Saving function is activated, slight condensation may form on the door of the appliance; normal operating conditions are restored when the function is deactivated. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. [. . . ] D) The yellow SUPERFREEZE indicator light flashes Heating is excessive a) The refrigerator door has remained open for more than two minutes (the buzzer will stop sounding when you shut the door) or the correct switchingoff procedure was not followed (see Maintenance). B) The temperature in the freezer is too high. Check the quality of the food products and dispose if necessary. C) The temperature in the freezer has reached a dangerous level. [. . . ]