User manual HASBRO SESAME STREET 1-2-3 HIGHWAY

[. . . ] Pass them on to possible new owners of the appliance. The compressor and condenser give off heat and require good ventilation to operate correctly and save energy. Leave a space of at least 10 cm between the top part of the appliance and any furniture above it, and at least 5 cm between the sides and any furniture/side walls. Ensure the appliance is away from any sources of heat (direct sunlight, electric stove, etc. [. . . ] If large quantities of food have been added or if the refrigerator door has been opened frequently, it is normal for the indicator not to show OK. Wait at least 10 hours before adjusting the TEMPERATURE control knob to a higher setting. Before starting the appliance, follow the installation instructions (see Installation). Before connecting the appliance, clean the compartments and accessories well with lukewarm water and bicarbonate. Insert the plug into the socket and ensure that the internal light illuminates. After a few hours you will be able to put food in the refrigerator. Using the refrigerator to its full potential • Use the TEMPERATURE ADJUSTMENT knob to adjust the temperature (see Description). • Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). • Remember that cooked foods do not last longer than raw foods. Do not store liquids in open containers. They will increase humidity in the refrigerator and cause condensation to form. The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. It is necessary to clean the discharge hole regularly so that the water can flow out easily. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W). Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. • If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. 1 1 2 17 Precautions and tips GB !The appliance was designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. [. . . ] • Do not touch the internal cooling elements: this could cause skin abrasions or frost/freezer burns. • When unplugging the appliance always pull the plug from the mains socket, do not pull on the cable. • Before cleaning and maintenance, always switch off the appliance and disconnect it from the electrical supply. It is not sufficient to set the temperature adjustment knobs on OFF (appliance off) to eliminate all electrical contact. [. . . ]