User manual HASBRO SOUNDS OF FUN THE LION KING

[. . . ] 15 Important Information GB For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below: Fluff Filter. You MUST clean the fluff filter after EVERY drying cycle. Pull out the filter (using the two finger grips). Clean any fluff deposits from the filter mesh. [. . . ] Q Post Creasecare (Anti-Froissage Fin de Cycle) When selected, the clothes are occasionally tumbled after the end of the drying and cool tumble cycles, to help prevent creases developing should you not be available to remove the load immediately the programme is complete. The End light (Fin) is on during this phase. Empty Water Light / Container (Bac Plein) (If you have plumbed your dryer to a drain this light can be ignored, as there is no need to empty the water container). When this light is on (not flashing) it reminds you to empty the water container. If the water container fills during a programme, the heater turns off and the dryer does a period of Cool Tumble then the light flashes and the buzzer sounds. You must empty the water container and restart the dryer or the clothes will not dry. After re-starting the dryer, the light will take a few seconds to go out. To avoid this always empty the water container each time you use the dryer (see Maintenance). Q OPTION buttons / lights These buttons are used to customise the selected programme to your requirements. Q During a delay phase the delay will continue to count down. The Start/Pause button (Départ/Pause) must be pressed to resume the delay programme. 1500g 1000g 700g 250g 100g 700g 350g 500g 350g (3lb 5oz) (2lb 3oz) (1lb 6oz) (9oz) (3oz) (1lb 6oz) (12oz) (1lb 2oz) (12oz) At the end of a drying cycle, cottons could still be damp if you grouped cottons and synthetics together. If this happens simply give them an additional short period of drying. Q Note: The last 10 minutes of any time set is the Cool Tumble, so allow for this when setting the time, as this period will not dry your laundry. 23 Laundry GB Special clothing items Blankets and Bedspreads: acrylic items (Acilan, Courtelle, Orion, Dralon) must be dried with special care on LOW heat setting. Pleated or creased garments: read the manufacturer’s drying instructions on the garment. Starched articles: do not dry these with non-starched items. Make sure that as much of the starch solution is removed from the load as possible before placing it in the dryer. Do not over-dry: the starch will become powdery and leave your clothing limp, which defeats the purpose of starch. Times are approximate and can vary depending upon: q Amount of water retained in clothes after spin cycle: towels and delicates retain a lot of water. Fabrics: items that are the same type of fabric but different textures and thicknesses may not have the same drying time. Quantity of laundry: single items or small loads may take longer to dry. [. . . ] The filter has not been cleaned (see Maintenance). The temperature setting is not ideal for the type of fabric you are drying (see Start and Programmes, and see Laundry). The correct drying time has not been selected for the load (see Laundry). The air intake grille or rear vents are obstructed (see Installation, and see Maintenance). [. . . ]