User manual HASBRO STEEPLE CHASE

[. . . ] To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. Remove the appliance from all packaging and check that it has not been damaged during transportation. If it has been damaged, contact the retailer and do not proceed any further with the installation process. [. . . ] Modifying the duration of a wash cycle already in progress If a mistake was made during the wash cycle selection process it is possible to change the cycle, provided that it has only just begun:press and hold the START/RESET button for 5 seconds After one long beep and three short beeps, the WASH CYCLE PHASE indicator light will switch off: select the new cycle and switch the machine back on by pressing the START/RESET button. Adding extra crockery Press the ON/OFF button and open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Press the ON/OFF button again: the cycle starts from the point at which it was interrupted. Washing options Delayed start It is possible to delay the start time of the cycle by 12, 9, 6 or 3 hours. Press the DELAYED START button: every time the button is pressed, a beep is emitted and the selected delayed start indicator light illuminates. Select the wash cycle and press the START/RESET button: after the beep sounds, the timer begins counting down. Once this time has elapsed, the indicator light switches off and the wash cycle begins. To adjust the delay time and select a smaller period of time, press the DELAYED START button. To cancel it, press the button repeatedly until the wash cycle begins and the WASH CYCLE PHASE indicator light corresponding to the start of the cycle in progress illuminates. Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. After cleaning check that the filter assembly has been replaced correctly. The dishwasher should not be used without filters or when the filter is loose. Remove the filters by pulling the handle upwards. • Any marks on the appliance interior may be removed using a cloth dampened with water and a little vinegar. Preventing unpleasant odours • Always keep the door of the appliance ajar in order to avoid moisture from forming and being trapped inside the machine. • Clean the seals around the door and detergent dispensers regularly using a damp sponge. This will avoid food becoming trapped in the seals, which is the main cause of the formation of unpleasant odours. Cleaning the sprayer arms Food residue may become encrusted onto the sprayer arms and block the holes used to spray the water. It is therefore recommended that the arms are checked from time to time and cleaned with a small nonmetallic brush. • The entire filter assembly should be cleaned thoroughly once a month: this includes the semicircular plate A, the glass B and the cylinder C (this may be removed by turning it in an anti-clockwise direction). Use a small nonmetallic brush to clean these parts. [. . . ] Th e filter is dirty o r blocke d (see C are a n d m a inten a n ce). Turn o n th e tap an d the ap plia nce w ill start after a fe w m in utes. No w ater drains out fro m the dishw asher. The dishes and g lasses are streaked or ha ve a b luis h tinge. [. . . ]