User manual HASBRO SUPERMAN MAN OF STEEL MATRIX CONVERSION COUPE

[. . . ] • Avoid installing the hob above a dishwasher: if this cannot be avoided, place a waterproof separation device between the two appliances. • Depending on the hob you want to install, the cabinet must have the following dimensions (see figure): 590 574 HOB FROM BELOW 48 52 0 48 50 4 56 0+ /- 1 49 0+ /- 1 56 0+ /- 1 49 0+ /- 1 Ventilation To allow adequate ventilation and to avoid overheating of the surrounding surfaces the hob should be positioned as follows: • At a minimum of 40 mm from the back panel and 600 mm from any other vertical surfaces. Above an empty cabinet or a drawer A space of at least 40 mm, or an opening of 5 mm on the width measurement of the cabinet, should be created. 40mm Opening of at least 5 mm on the overall width measurement of the surface. [. . . ] voltage and mains frequency 400V 3-N ~ ı 50 Hz Electrical connections Terminal board Three-phase 400 GB 5. Secure the power supply cable by fastening the cable clamp screw, then put the cover back on. Single-phase connection 2 4 1 The hob is equipped with a preconnected electricity supply cable, which is designed for single-phase connection. Connect the wires according to the instructions given in the following table and diagrams: Voltage and mains frequency 230V 1+N ~ 50 Hz Electrical cable Wire connection : yellow/green; N: the two blue wires together L: brown and black together 3 5 Three-phase 400 Phase U-bolt Phase Phase Neutral Earth connection support This appliance conforms to the following European Economic Community directives: - 73/23/EEC dated 19/02/73 (Low Voltage) and subsequent amendments; - 89/336/EEC dated 03/05/89 (Electromagnetic Compatibility) and subsequent amendments; - 93/68/EEC dated 22/07/93 and subsequent amendments. Other types of connection If the mains supply corresponds with one of the following: Voltage and mains frequency • 400V - 2+N ~ 50 Hz • 230V 3 ~ 50 Hz • 400V - 2+2N ~ 50 Hz Separate the wires and connect them according to the instructions given in the following table and diagrams: Voltage and mains frequency 400V - 2+N ~ 50 Hz 230V 3 ~ 50Hz Electrical cable Wire connection : yellow/green; N: the two blue wires together L1: black L2: brown : yellow/green; N1: blue 400V - 2+2N ~ 50 Hz N2: blue L1: black L2: brown Disposal • When disposing of packaging material: observe local legislation so that the packaging may be reused. • The European Directive 2002/96/EC relating to Waste Electrical and Electronic Equipment (WEEE) states that household appliances should not be disposed of using the normal solid urban waste cycle. Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. For further information relating to the correct disposal of exhausted household appliances, owners may contact the public service provided or their local dealer. If the mains supply corresponds with one of the following: Voltage and mains frequency • 400V 3 - N ~ 50 Hz proceed as follows: 9 Description of the appliance GB The control knobs (C) Su pe er ow rP A A Each cooking area is equipped with a control knob to regulate the temperature at any time from a minimum of 1 to a maximum of 12. The table 1 provides information on the settings indicated on the knobs and the corresponding, recommended uses. If this happens, disconnect the appliance from the electricity mains immediately and contact a Service Centre. • If the surface of the hob is cracked, switch off the appliance to prevent electric shocks from occurring. • Ensure that power supply cables of other electrical appliances do not come into contact with the hot parts of the hob. • Remember that the cooking zones remain relatively hot for at least thirty minutes after they have been switched off. An indicator light provides a warning when residual heat is present (see Start-up and use). • Keep any object which could melt away from the hob, for example plastic and aluminium objects, or products with a high sugar content. Be especially careful when using plastic film and aluminium foil or packaging: if placed on surfaces that are still hot, they may cause serious damage to the hob. • Always make sure that pan handles are turned towards the centre of the hob in order to avoid accidental burns. • When unplugging the appliance, always pull the plug from the mains socket; do not pull on the cable. • Never perform any cleaning or maintenance work without having disconnected the appliance from the electricity mains. Do not place metal objects (knives , spoons , pan lids , etc. [. . . ] Never use steam cleaners or pressure cleaners on Disassembling the hob If it is necessary to disassemble the hob: 1. Loosen the screws fixing the alignment springs on each side. Loosen the screws holding the fixing hooks in each corner. Take the hob out of its installation cavity. [. . . ]