User manual HASBRO TECHNO ZOIDS ELECTRONIC EVIL PEGASUS

[. . . ] Connecting the water inlet hose • To a suitable cold water connection point: before attaching the hose, run the water until it is perfectly clear so that any impurities that may be present in the water do not clog the appliance; after performing this operation, screw the inlet hose tightly onto a tap with a ¾ gas threaded connection. • To a suitable hot water connection point: your dishwasher may be supplied with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance). [. . . ] It starts again from the point at which it was interrupted once the door has been shut or once the electricity supply is restored. 18 Wash cycles If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. The number and type of wash cycles and options may vary depending on the dishwasher model. Pre-wash for dishes while awaiting completion of the load with the dishes from the next meal. Environmentally-friendly wash cycle with low energy consumption levels, suitable for pans and dishes. Economic and fast wash to be used for lightly soiled dishes. (Run cycle immediately after use) (2 plates + 2 glasses + 4 pieces of cutlery + 1 saucepan + 1 small frying pan). The rinse aid dispenser should be filled: • When the LOW RINSE AID* indicator light on the control panel is illuminated; 1. Open the dispenser by turning the lid (G) in an anticlockwise direction. Pour in the rinse aid, making sure it does not overflow from the dispenser. If this happens, clean F the spill immediately with a dry G cloth. - Press the ON/OFF button; the wash cycle phase indicator 20 * Only available in selected models. Care and maintenance Shutting off the water and electricity supplies Clean the water inlet filter at the tap outlet regularly. - Unscrew the end of the water inlet hose, remove the filter and clean it carefully under running water. - Replace the filter and screw the water hose back into position. • Turn off the water tap after every wash cycle to avoid leaks. • Always unplug the appliance when cleaning it and when performing maintenance work. • The external surfaces of the machine and the control panel may be cleaned using a non-abrasive cloth which has been dampened with water. do not use solvents or abrasive products. • Any marks on the inside of the appliance may be removed using a cloth dampened with water and a little vinegar. Cleaning the dishwasher Cleaning the filters The filter assembly consists of three filters which remove food residues from the washing water and then recirculate the water. They should be cleaned if you wish to achieve the best results in every wash. [. . . ] The w ash cycle is too gentle (see W ash cycles). An e xc essive am ou nt of fo am h as b e en pro d uce d: th e deterg e nt h as not been m eas ured out correctly or it is not suitable for use in dishw ashers (see Start-up and use). The lid on the rinse aid compartm ent has not been s hut correctly. The filter is dirty or blocked (see Care and maintenance). [. . . ]