User manual HASBRO TRANSFORMERS ALTERNATORS SMOKESCREEN

[. . . ] Make sure that the instructions are kept with the appliance if it is sold, given away or moved. The appliance must be installed by a qualified professional according to the instructions provided. Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. Room ventilation The appliance may only be installed in permanentlyventilated rooms, according to current national legislation. [. . . ] In the case of natural gas, the adjustment screw must be unscrewed by turning it anti-clockwise. Turn the knob from the MAX position to the MIN position quickly or open and shut the oven door, making sure that the burner is not extinguished. TECHNICAL DATA Oven Dimensions HxWxD Volume Useful measurements relating to the oven compartment Voltage and frequency Burners 31x43, 5x43, 5 cm 58 l width 46 cm depth 42 cm height 8, 5 cm see data plate may be adapted for use with any type of gas shown on the data plate. The glass lid can break in if it is heated up. Turn off all the burners and the electric plates before closing the lid. *Applies to the models with glass cover only. CG65SG5 UA/HA CG65SG1 UA/HA 6 Description of the appliance Overall view Glass cover* GB Gas burner Hob grid Control panel Containment surface for spills GUIDE RAILS for the sliding racks position 5 position 4 position 3 position 2 position 1 Adjustable foot GRILL rack DRIPPING PAN Adjustable foot Control panel GRILL PILOT LIGHT ELECTRONIC TIMER* Hob BURNER control knobs J OVEN control knob OVEN LIGHT and ROTISSERIE button GRILL PILOT LIGHT TIMER* Hob BURNER control knobs OVEN control knob OVEN LIGHT and ROTISSERIE button * Only available in certain models. 7 Start-up and use Using the hob Lighting the burners For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner. To light one of the burners on the hob: 1. Bring a flame or gas lighter close to the burner. Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting E. timer* To activate the Timer proceed as follows: 1. Turn the TIMER knob in a clockwise direction 4 for almost one complete revolution to set the buzzer. Turn the TIMER knob in an anticlockwise direction 5 to set the desired length of time. Every time the + button is pressed it corresponds to a time increase of 10 seconds, until it reaches 99 minutes and 50 seconds. After this point, each press of the button represents an increase of one minute, up to a maximum of 10 hours. After the time period has been set, the timer will begin to count down. When the timer reaches zero, the buzzer will sound (this may be stopped by pressing any button). The time may be displayed by pressing the G button, and the n symbol indicates that the timer function has been set. After approximately 7 seconds, the display will automatically revert to the timer. Cancelling a time that has already been set Press the – button until the display shows 0:00. Adjusting the buzzer volume After selecting and confirming the clock settings, use the – button to adjust the volume of the alarm buzzer. [. . . ] 11 Care and maintenance Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Inspecting the oven seals Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Authorised After-sales Service Centre. We recommend that the oven is not used until the seals have been replaced. [. . . ]