User manual HASBRO TRANSFORMERS ARMADA CYCLONUS WITH CRUMPLEZONE MINICON

[. . . ] Make sure that the instructions are kept with the appliance if it is sold, given away or moved. The appliance must be installed by a qualified professional according to the instructions provided. Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. Levelling If it is necessary to level the appliance, screw the adjustable feet into the places provided on each corner of the base of the cooker (see figure). [. . . ] € Place the dripping pan on the bottom and the rack on top. GRILL • When using the GRILL and DOUBLE GRILL cooking modes, place the rack in position 5 and the dripping pan in position 1 to collect cooking residues (fat and/or grease). When using the GRATIN cooking mode, place the rack in position 2 or 3 and the dripping pan in position 1 to collect cooking residues. € We recommend that the power level is set to maximum. The top heating element is regulated by a thermostat and may not always operate contantly. B MULTI-COOKING mode All the heating elements (top, bottom and circular) switch on and the fan begins to operate. Since the heat remains constant throughout the oven, the air cooks and browns food in a uniform manner. A maximum of two racks may be used at the same time. d GRILL mode The central part of the top heating element is switched on. The high and direct temperature of the grill is recommended for food that requires a high surface temperature (veal and beef steaks, fillet steak and entrecôte). This cooking mode uses a limited amount of energy and is ideal for grilling Place the food in the centre of the rack, as it will not be cooked properly if it is placed in the corners. Press the numerical digits on the display begin to flash. Use the “+” and “-” buttons to adjust the minute value. If none of the buttons are pressed, the settings will be confirmed automatically after 10 seconds have passed. Manual Mode The programmer after the Power up and the Clock time setting will be in ‘Manual Mode’ and shall be possible to engage the other programmer functions selector. Using the The oven will be driven directly by the user by means of the knobs present on the control panel. The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special nonabrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. Practical advice on using the hob • Use pans with a thick, flat base to ensure that they adhere perfectly to the cooking zone. GB Switching the cooking zones on and off To switch on a cooking zone, turn the corresponding knob in a clockwise direction. To switch it off again, turn the knob in an anticlockwise direction until it is in the “0” position. [. . . ] Remove spills as soon as possible, without waiting for the appliance to cool, to avoid residues forming crusty deposits. You can obtain excellent results by using a rustproof steel wire sponge - specifically designed for glass ceramic surfaces - soaked in soapy water. € If plastic or sugary substances have accidentally been melted on the hob, remove them immediately with the scraper, while the surface is still hot. € Once it is clean, the hob may be treated with a special protective maintenance product: the invisible film left by this product protects the surface from drips during cooking. [. . . ]