User manual HASBRO TRANSFORMERS UNIVERSE DINOBOT STRIKER

[. . . ]  If the appliance is levelled correctly it will be more  Please read this instruction manual carefully it stable and much less likely to cause vibrations and noise during the spin cycle.  If positioned on a fitted carpet or a rug, adjust the feet in such a way as to allow room for air to circulate and provide ventilation beneath the washer-dryer.  You will find the guarantee and other details relating to Connecting the water and electricity supplies Connecting the water inlet hose Unpacking and levelling Unpacking Before connecting the inlet hose to the water supply, allow the water to flow from the tap until it runs clear. Connect the inlet hose to the machine, by screwing it into the cold water inlet on the upper right hand side of the back of the machine (see figure). [. . . ] During the wash cycle, the display will show which stage is currently in progress and the icon corresponding to each stage will illuminate. To change a programme while a cycle is in progress, pause the washer-dryer by pressing the START/ PAUSE button; then select the desired cycle and press the START/PAUSE button again. To open the door while a cycle is in progress press the START/PAUSE button; if the DOOR LOCK indicator light switches off it is possible to open the door. Press the START/PAUSE button again to resatrt the programme from the point at which it was interrupted. The text END lights up to indicate that the programme has ended. The porthole door may be opened immediately. If the START/PAUSE button flashes, press the button to end the cycle. Open the door, unload the laundry and switch off the machine.  Exception: if the COTTON WHITES programme is selected, the temperature can be increased up to a value of 90°C.  If you wish to cancel a cycle that has already begun, press and hold the button. The cycle will be stopped and the machine will switch off. we recommend that you use a powder detergent. Stubborn stains: stubborn stains should be treated with solid soap before the garment is washed (use the Cotton programme with pre-wash phase). GB  Do not use detergents when washing garments by hand, because they create too much foam. The detergent must be measured out into the relevant compartment, or into the detergent dosing ball which will be placed directly into the drum of the machine. In this case the Cotton cycle with pre-wash phase may not be selected. Load-balancing system Before every spin cycle, to avoid excessive vibrations and to distribute the load in a uniform manner, the drum rotates continuously at a speed which is slightly faster than the normal washing speed. If, after several attempts, the load is still not evenly distributed, the machine spins at a lower speed than the set frequency. If the load is excessively unbalanced, the washerdryer continues at distribution speed only instead of the full spin speed. In order to achieve better load distribution and balance, we recommend that large and small garments are mixed when placing the laundry in the machine. Preparing the laundry  Unfold all items of laundry before placing them in the machine. • Divide the laundry according to type of material (the symbol on the garment label) and colour, making sure that whites are separated from coloured garments. [. . . ] • The end of the outlet hose has not been fitted at a height between 65 and 100 cm from the floor (see “Installation”). • The free end of the hose is underwater (see “Installation”). • If If the dwelling is on one of the upper floors of a building, there may be problems relating to water drainage, causing the washer-dryer to load and drain water continuously. Special anti-draining valves are available in shops and help to avoid this inconvenience. [. . . ]