User manual HASBRO TRANSFORMERS CANNON BUMBLEBEE

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] Add rinse aid to the corresponding container only if you are dissatisfied with the results on your dishes. In any case, please read the manufacturer's instructions provided on the packet. If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number of cycles. 16 ARISTON DISHWASHER - Instructions for installation and use Select the right wash cycle D ISHWASHER Select the right wash cycle for your dishes. Selecting the most suitable wash cycle for the load ensures clean dishes and a more convenient use of water and electricity. A wash cycle for every degree of soil Salt, rinse aid, the right amount of detergent and the correct wash cycle: this is the formula to get the best results and to keep your dishwasher in shape &\FOH &\FOH VHOHFWLRQ LQVWUXFWLRQV &\FOH GHVFULSWLRQ 'HWHUJHQW IRU SUHZDVK  ZDVK :DVK F\FOH GXUDWLRQ WROHUDQFH “ 5LQVH $LG ZLWKRXW H[WUD GU\LQJ Very dirty dishes and pans (not to be used for delicate items) , QWHQVLYH :DVK Pre-wash with hot water at 40°C Extended wash at 65°C 2 Rinses with cold water Rinse with hot water at 65°C Drying    J  Cycle for normally dirty pans and dishes. Extended wash at 50° Cold rinse Rinse with hot water at 70°C Drying  J  'DLO\ :DVK Preliminary wash cycle for dishes while awaiting completion of the load with the dishes from the next meal. Short cold wash to prevent food from drying onto the dishes  6RDNLQJ Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes. 2 Cold pre-washes Extended wash at 50°C Hot rinse at 65°C Drying    J  ARISTON DISHWASHER - Instructions for installation and use 17 D ISHWASHER Never Loading the salt. Always use salt which is intended for dishwasher use. The salt container is situated underneath the lower rack, fill it up as follows: 1. This electric household appliance should be connected to the water mains using the cold water supply hose provided with the appliance only. In the event of replacements, use original spare parts only. Your dishwasher can be supplied with hot water from the mains supply (if you have a central heating system with radiators) at a temperature of no more than 60°C. In this case, the wash cycle time will be about 15 minutes shorter and the wash will be slightly less effective. The connection must be made to hot water supply following the same procedures as those indicated for the cold water connection. Fit the drain pipe into a drain line with a minimum diameter of 4 cm or place it over the sink. Use the special plastic elbow provided (see figure) to position it in the best possible way. The part of the pipe marked with the letter A should be between 40 and 100 cm above the ground. The pipe should not be immersed in water. First of all, check that the mains voltage and frequency values correspond to those stated on the rating plate located on the stainless steel inner door of the appliance and that the electrical system to which the dishwasher is connected is sized for the maximum current indicated on said rating plate. Only now can you plug the appliance into a socket provided with an efficient earth connection (the system's earthing is a guarantee of safety provided for by law, make sure your system has it). [. . . ] Improper replacement of the filters may reduce the efficiency of the wash and even damage your dishwasher. 1 B 2 A C Keep your dishwasher in shape Respecting these few rules ensures you will always have a reliable work companion by your side. When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. [. . . ]