User manual HASBRO TREASURE ROCKS SUPER STAR SET

[. . . ] Putting your appliance in place and moving it. If your washing machine is equipped with a special set of retractable wheels you can easy move it. To lower the wheels and thus move the appliance effortlessly, just pull the lever, situated on the left-hand side beneath the base. Once the appliance is in the required position, put the lever back in place. [. . . ] 18 Personalisations Setting the spin cycle GB If, when the appliance is switched on, the KNOB is positioned on a appears. Press button programme with a spin cycle, a fixed and the maximum spin speed allowed for the programme set will be displayed, and the the icon goes on. Press it again and the values lower until they reach OFF, which indicates that the spin cycle has been excluded (press it again to go back to the maximum value); stop on the desired speed, after approximately 2 seconds remains fixed. The setting is accepted: the symbol The spin cycle setting is enabled with all the programmes except for 11 (curtains, silk) and the Draining cycle. If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature needs appears. Press button and the maximum temperature allowed for the programme to be regulated, a fixed set will be displayed and the icon flashes. Press it again and the temperature lowers until it reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the desired value, remains fixed. After approximately 2 seconds the setting is accepted: the symbol The temperature adjustment is enabled with all wash programmes. Setting the temperature Setting the Delay Timer Press the button and you will see the word OFF on the display, while the relative symbol flashes. Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the "desired" delay; after approximately 2 seconds the setting is accepted, following which, the time for the set remains on. Programme appears on the display and the symbol If you now press the START/RESET button, the set "delay" appears; this decreases every hour until the start of the cycle. • Disposing of an old washing machine: before scrapping your appliance, cut the power supply cable and remove the appliance door. GB General safety • This appliance has been designed for nonprofessional, household use and its functions must not be changed. • This washing machine should only be used by adults and in accordance with the instructions provided in this manual. • Never touch the washing machine when barefoot or with wet or damp hands or feet. • Do not pull on the power supply cable to unplug the appliance from the electricity socket. • Do not open the detergent dispenser while the appliance is in operation. • Do not touch the drain water as it could reach very high temperatures. • Never force the washing machine door: this could damage the safety lock mechanism designed to prevent any accidental openings. • In the event of a malfunction, do not under any circumstances touch internal parts in order to attempt repairs. • Always keep children well away from the appliance while in operation. • The appliance door tends to get quite hot during the wash cycle. [. . . ] • The free end of the hose is underwater (see page 15). • The wall drainage system doesn't have a breather pipe. If the problem persists even after these checks, turn off the water tap, switch the appliance off and call for Assistance. If the dwelling is on one of the upper floors of a building, there may be drain trap problems causing the washing machine to load and unload water continuously. [. . . ]