User manual HASBRO WIPE-OFF OUTLINE MAP

[. . . ] For a complete electrical disconnection, pull out the main plug. The socket-outlet shall be installed near the equipment and shall be easily accessible. T The CE mark logo label is affixed on an equipment in case that the directives described in the above sentence are applicable to the product. (This sentence is not applicable in any country where the above directives are not required. ) OUTLINE OF THIS MANUAL 1. GETTING STARTED This chapter describes the basic information on the use of this copier. 2 1 2 3 4 5 6 7 2. MAKING COPIES This chapter describes the basic copying functions such as normal copying, reduction or enlargement, and exposure adjustments. 3. SPECIAL FUNCTIONS This chapter describes special copying functions including various image editing functions. 4. COPIER TROUBLE? This chapter describes how to remove misfed paper and how to remedy minor problems. 5. GENERAL INFORMATION This chapter describes general information about the use of the copier and the loading of paper and toner. 6. OPTIONAL EQUIPMENT This chapter describes operating instructions for the Single Pass Feeder (AR-SP4), the Reversing Single Pass Feeder (AR-RP3), the Finisher (AR-FN5), the 500-Sheet Paper Feed Unit (AR-D11), and the 2 x 500-Sheet Paper Feed Unit (AR-D12). 7. KEY OPERATOR'S GUIDE This chapter contains information about all programs for use by the key operator. [. . . ] tray holds up to 500 sheets of 80 g/m2 (21 lb. ) paper. q Do not load paper above the maximum height line. q The 5 Push the paper tray firmly back into the copier. q If the paper size is changed in steps 3 and 4, place the paper size card in the front of the paper tray to indicate the selected paper size. Proceed to the next section. 5 GENERAL INFORMATION 51/2x81/2 A5 B5 R A4 A3 81/2x13 81/2x11 81/2x14 81/2x13 Paper size card 81/2x11R A4 R 11x17 A4 EXTRA EXTRA B4 B5 81/2x11 Paper size card 79 PAPER Changing the copy paper size in the tray Paper size setting can only be done while the machine is not operating and the COPY mode has been selected. q B5 paper cannot be set for paper tray 2. 1 Press the SPECIAL FUNCTION key. q The SPECIAL FUNCTION screen will appear. SPECIAL FUNCTION SPECIAL MODES ORIG. SIZE ENTER PAPER SIZE SET DISPLAY CONTRAST 2 Use the key. q The and keys to select "PAPER SIZE SET" and press the OK paper size setting screen will appear. PAPER SIZE SET A4 A3 A3 B4 A4 A4R 3 Use the and keys to select the paper tray for which the paper size is being changed. GENERAL INFORMATION 4 Press the key. PAPER SIZE SET A4 A3 2 A3 B4 A4 A4R 80 PAPER 5 Use the and keys to select the paper size that has been set. q To change the size of another paper tray, press the key and then repeat steps 3 to 5. 6 Press the OK key. qA confirmation message for paper size setting will appear. 7 Press the OK key. q The specified paper size will be registered and the display will return to the basic screen. 5 GENERAL INFORMATION 81 TONER CARTRIDGE REPLACEMENT The approximate quantity of toner remaining can be displayed by pressing and holding the COPY key during standby or warm-up. When the quantity of toner remaining is less than 25%, obtain a new cartridge. When the toner cartridge replacement required icon ( ) appears in the display, replacement of the toner cartridge will be needed soon. If you press the information key, the message "Toner is low. " will appear in the display. Can not copy or print. " appears in the display, the toner cartridge must be replaced before copying can be resumed. Replace the toner cartridge by following the procedure below. NOTE: During a long copy run of a dark original, the message "Toner replenishment in progress. " may appear, even though there is toner remaining and the copier will suspend the copying job whilst it replenishes its toner supply. Only genuine HASBRO consumables carry the Genuine Supplies label. GENUINE SUPPLIES Proper storage 1 2 Store the supplies in a location that is: q clean q at and dry, a stable temperature, q not exposed to direct sunlight. Store copy paper in the wrapper and lying flat. q Paper stored in packages standing up or out of the wrapper may curl or become damp, resulting in paper misfeeds. GENERAL INFORMATION 88 SPECIFICATIONS WIPE-OFF OUTLINE MAP Type Copy system Originals Original sizes Copy sizes Digital laser copier/printer, desktop Dry, electrostatic transfer Sheets, bound documents Max. A6 (5-1/2" x 8-1/2") Image loss: Max. 4 mm ( 5/32") (leading and trailing edges), Max. 3 mm (1/8") (along other edges) Copying speed (one-sided copying at 100% copy ratio) 600 dpi 23 copies/min. (A4 (8-1/2" x 11")) 27 copies/min. (A4 (8-1/2" x 11")) 16 copies/min. (A4R (8-1/2" x 11"R)) 18 copies/min. (A4R (8-1/2" x 11"R)) 14 copies/min. (A3 (11" x 17")) 1200 dpi 13. 5 copies/min. (A4 (8-1/2" x 11")) 9 copies/min. (A4R (8-1/2" x 11"R)) 8. 5 copies/min. (8-1/2" x 14") 7. 5 copies/min. [. . . ] : In a study in rats of chronic inhalation exposure to a typical toner, a mild to moderate degree of lung fibrosis was observed in 92% of the rats in the high concentration (16mg/m3) exposure group, and a minimal to mild degree of fibrosis was noted in 22% of the animals in the middle (4mg/m3) exposure group, but no pulmonary change was reported in the lowest (1mg/m3) exposure group, the most relevant level to potential human exposures. Chronic Effect 12. ECOLOGICAL INFORMATION No data are available. 13. DISPOSAL CONSIDERATION Waste from residues : Waste material may be dumped or incinerated under conditions which meet all federal, state and local environmental regulations. Contaminated Packaging : Waste may be disposed or incinerated under conditions which meet all federal, state and local environmental regulations. 14. [. . . ]