User manual HASBRO ZORRO

[. . . ] If the AR-151/ZORRO is used with the facsimile expansion kit AR-FX3 or if it is an AR-F152, please refer to the attached Declaration of Conformity on the rear inside cover page. 1-12) 2 Light ({) and dark (}) keys and exposure indicators ) Use to adjust the MANUAL (=) or PHOTO ( exposure level. 1-22) 4 Copy ratio selector key and copy ratio indicators Use to sequentially select preset reduction/ enlargement copy ratios. 1-14) 7 Display Displays the specified copy quantity, zoom copy ratio, user program code, and error code. [. . . ] If the original image is bigger than the paper or media, this may cause smudging on the edges of the copies. To close the bypass tray, perform step1 and then step 2 in the illustration and push the round projections at the right of the tray until they click. Set the paper guides to the copy paper width. Insert the copy paper (print face down) all the way into the bypass tray. Paper must be fed narrow side into the feed slot. Transparency film, labels, and other special purpose papers must be fed individually. When copying onto transparency film, remove each copy promptly. When loading an envelope, make sure that it is straight and flat. Set the number of copies if using standard copy paper. Two-sided copying can be made on this copier using the manual bypass. Example: The following two originals will be copied onto two sides of copy paper. Auto clear (page 1-19) The copier returns to the initial settings a preset amount of time after the last copy is made. This preset amount of time (auto clear time) can be changed. Press and hold down the exposure mode selector key for approximately 5 seconds. To enter the toner save mode, press the light ({) key. The exposure indicator marked "1" will light up, indicating the toner save mode is selected. To return to the standard mode, repeat the procedure but use the dark (}) key to select exposure level "5" in step 3. The user programs allow the parameters of certain functions to be set, changed, or cancelled as desired. Setting the power save modes and auto clear time, and stream feeding mode. Press and hold down the light ({) and dark (}) keys simultaneously for more than 5 seconds until all the alarm indicators (q, t, s and p ) blink and "­ ­" appears in the display. Use the left copy quantity (<) key to select a user program number. The selected number will blink in the left side of the display. [. . . ] A letter and a number appear alternately. The memory backup funtion for facsimile maintains data only for one hour. When any facsimile data is kept in memory, do not keep the copier power turned off (by unplugging the power cable) for a long time even if the copier stops due to trouble. Use the following procedure to display the total number of copies. [. . . ]