User manual HASSELBLAD FLEXTIGHT 343

[. . . ] · Do not start scanning or previewing until an original holder with an original has been mounted. is in the load position. · The original holder is only to be mounted or removed when the drum · When you turn on the scanner, the drum will roll to the load position, if it is not there already. Do not touch the scanner while the drum is rotating. is connected to power. · Do not place your fingers or any other object into the scanner while it · Before servicing or opening the scanner, the power supply must be · Install the scanner in a location where children can not get to it. [. . . ] IMPORTANT: Make sure that the wall socket you are planning to use meets the electrical requirements outlined earlier. Plug the Flextight 343 power supply into a wall socket. Note that the power supply may emit a low buzzing sound when plugged in. This is normal and will not damage the power supply or scanner. Turn the scanner around so that the front is facing you. Turn on your computer and install the FlexColor image scanning software. 3. 6. User's Guide - Flextight 343 English 1. Place the scanner on a table near your computer with the front facing away from you. Make sure that the location you choose meets all environmental - and electrical requirements as described on page 10. 12 Hardware Reference - Flextight 343 Operating the Scanner English F A B FLEXTIGHT ORIGINAL HOLD ER G H C PATENT PEND ING J à D E Figure 4: Operating the Flextight 343 scanner User's Guide - Flextight 343 Hardware Reference - Flextight 343 Operating the Scanner 13 Operating the Scanner (See Figure 4 opposite). It is assumed that the scanner and FlexColor software have been properly installed. Pull the feed table (B) down to scan position. Press the power button (G) on the front of the scanner to switch it on. The indicator light (F) button will start flashing green, indicating that no firmware has been downloaded yet. It will be downloaded automatically later when you first run the FlexColor program. Turn on your computer and launch the FlexColor program. The indicator light (F) will stop flashing indicating that firmware has been downloaded to the scanner. Select the original holder (D) that matches your original. Place the original holder with the slotted tab facing into the scanner. The flexible magnetic layer (C) must face upwards and the holder must fit between the guides (A) on both sides of the feed table. Slide the holder gently into the original holder clasp (H) at the scanner entrance. It will slip about ½ cm (1/4 inch) into it. It slips in very easily and is held in place by a pair of magnets. To remove the holder, simply pull it gently backwards. [. . . ] Standards to which Conformity is declared: EN61000-6-1 2001, EN61000-6-3 2001 and EN60950:2000. Manufacturer: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Hasselblad A/S Hejrevej 30 DK-2400 Copenhagen NV/ Denmark Type of Equipment: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Desktop CCD scanner Model name: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Flextight 343 The undersigned, hereby declare that the equipment specified above conforms to the above Directives and Standards. [. . . ]