User manual HASSELBLAD FLEXTIGHT 646

[. . . ] User's Guide Flextight 646 English 2 English © 2004 Hasselblad A/S. Flextight 646 User's Guide, Part No 70030050, revision A. The information in this manual is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Hasselblad A/S. Hasselblad A/S assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual. [. . . ] The button will start flashing green, indicating that no firmware has been downloaded yet. It will be downloaded automatically later when you first run the FlexColor program. Turn on your computer and launch the FlexColor program. The power button (E) will stop flashing indicating that firmware has been downloaded to the scanner. Select the original holder that matches your original: · For transparencies, choose one of the holders (H) that has a square hole in it. · For reflectives, select the large A4/letter-size holder (L) with the clear plastic layer (not included in the standard delivery). Place the original holder with the slotted tab facing into the scanner. For transparency holders (H), the flexible magnetic layer (D) must face upwards and the holder must fit between the guides (C) on both sides of the feed table. For the reflective holder (L), the clear plastic sheet must face upwards. Make sure that the slot (K) in the leading edge of the holder catches the notch (J) in the center of the original holder clasp (F). Slide the holder gently into the original holder clasp (F) at the scanner entrance. It will slip about ½ cm (1/4 inch) into it. It slips in very easily and is held in place by a pair of magnets. resolutions (in ppi) available with each of the original holders when scanning in True Resolutions mode. Original 35 mm Portrait 35 mm Landscape 45 x 60 mm Portrait * 60 x 60 - 60 x 70 mm 4" x 5" Portrait 13 x 18 Portrait * A4 Portrait * Table 1: True Resolutions Max. resolution (PPI) at full scanning width. 6300 5000 4000 3200 2040 1600 960 *) Not included in the standard delivery Calibrating the Scanner The scanner requires two types of calibration: · Focus calibration adjusts the positioning of the scanner's optics for each zoom level. If your scans are coming out unfocused or at slightly the wrong size, then you may need to make a new focus calibration to adjust the zoom mechanism. The focus calibration is stored in the scanner's flash PROM, so it is preserved when you move the scanner to a new computer. See "Focus Calibration" on page 21 for more information. During calibration, the scanner scans a white target to establish the white point along the full length of the scanner's CCD. The white calibration is stored in the scanner's flash PROM, so it is preserved when you move the scanner to a new computer. [. . . ] · Pull the tube gently out of the holders and then sideways out of the scanner. Insert the replacement tube and mount it into the holders making sure that it is properly held in place by the flaps. User's Guide - Flextight 646 English 26 Hardware Reference - Flextight 646 Replacing the Light Tubes English B A E C D PULL OUT PRESS à PRESS PULL OUT Figure 9: Replacing the Light Tubes User's Guide - Flextight 646 Hardware Reference - Flextight 646 Cleaning the External Surface of the Scanner 27 9. Connect the plug (C). 11. Mount the cabinet (B) and the feed table (A) following the reverse of the procedure used when removing them. When mounting the cabinet (B) make sure that it goes free of all cables and extrusions. [. . . ]