User manual HASSELBLAD FLEXTIGHT 848

[. . . ] User's Guide Flextight 848 English 2 English © 2004 Hasselblad A/S. Flextight 848 User's Guide, Part No 70030049, revision A. The information in this manual is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Hasselblad A/S. Hasselblad A/S assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual. [. . . ] Select the original holder (K) that matches your original: · For transparencies, choose one of the holders that has a square hole in it. The original must completely fill the hole with no edges showing. Also, no edges of the original must extend past the outer edges of the holder. The feed table (A) must be in normal position. · For reflectives, select the large A4/letter-size holder with the clear plastic layer. The feed table (A) must be in normal position. · For 35 mm slide frames use the optional 35 mm slide mount holder. The feed table (A) must be adjusted to horizontal position. This is obtained by lifting the table slightly upwards while pushing it gently into the scanner. Please note that when scanning 35 mm slide frames in the 35 mm slide mount holder it is recommended to use autofocus. See the FlexColor Software Reference for details. continues. . . 4. 5. User's Guide - Flextight 848 English 16 Hardware Reference - Flextight 848 Operating Instructions English CLOSED HORIZONTAL NORMAL D A E F G FLEX TIG HT à H J OR IGINA L HO LD ER PATE NT PE ND ING à L K B C Figure 4: Operating the Flextight 848 scanner User's Guide - Flextight 848 Hardware Reference - Flextight 848 Operating Instructions 17 . . . continued NOTE!Each original holder has it's own unique identification code (a combination of small rectangular holes at the holder's leading edge). These codes, combined with the scanner's ability to detect the feed table position, ensure that the scanner will not operate unless the feed table position matches the selected original holder. Place the original holder (K) with the slotted tab facing into the scanner. For transparencies, the flexible magnetic layer must face upwards. For reflectives, the clear plastic sheet must face upwards. Make sure that the original holder fits between the appropriate guides (C) or (D) on both sides of the light table. Original 35 mm Portrait 35 mm Landscape 45 x 60 mm Portrait 60 x 60 - 60 x 70 mm 4" x 5" Portrait 13 x 18 Portrait A4 Portrait Table 1: True Resolutions Max. resolution (ppi) at full scanning width. 8000 5000 4000 3200 2040 1600 960 User's Guide - Flextight 848 English 20 Hardware Reference - Flextight 848 Calibrating the Scanner Calibrating the Scanner English The scanner requires two types of calibration: · Focus calibration adjusts the positioning of the scanners optics for each zoom level. If your scans are coming out unfocused or at slightly the wrong size, then you may need to make a new focus calibration to adjust the zoom mechanism. [. . . ] 7. User's Guide - Flextight 848 English 26 Hardware Reference - Flextight 848 The Light Tubes English 1 D 2 C B A G F E PULL OUT PRESS à PRESS PULL OUT Figure 7: Replacing the Light Tubes User's Guide - Flextight 848 Hardware Reference - Flextight 848 Cleaning the External Surface of the Scanner 27 . . . continued · Press the flaps backwards to release the tube. · Pull the tube gently out of the holders and then sideways out of the scanner. Insert the replacement tube and mount it into the holders making sure that it is properly held in place by the flaps. 10. IMPORTANT: The "T" on the lamp board cover (G) indicates the socket for the transparencies tube. [. . . ]