User manual HATCO DHLM-0105

[. . . ] Decorative Heat Lamps DL Series Installation & Operating Manual I&W #07. 05. 147. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Hatco provides track kits in three different lengths: · L651 - 4 ft. When installing or using this Trac system, the 7 R Mount Figure 6. Non-Track Mounting following basic safety precautions should always be followed: · · Read all of these installation instructions before installing the Trac system. Save these instructions and refer to them when additions to or changes in the Trac configuration are made. Do not install this Trac in damp or wet locations. Do not install any part of a Trac system less than 5 feet (1524 mm) above the floor. Do not install any fixture assembly closer than 1" (25 mm) along the sides from any curtain or similar combustible material. Disconnect electrical power before adding to or changing the configuration of the Trac. Do not attempt to energize anything other than Trac lighting fixtures on the Trac. To reduce the risk of fire and electric shock, do not attempt to connect power tools, extension cords, appliances, etc. DHLM-0105 · · · · · INSTALLATION CAUTION For safe and proper operation do not use Trac system units with a power supply cord or convenience receptacle adapter. CAUTION To reduce the risk of fire and electric shock when installing Trac systems, use only fixture assemblies marked for use with Halo Trac, and Trac Fittings marked for use with L650 Series Trac. The mounting clips, screws or stems are to be mounted in pre-drilled holes as follows: · · · · 2 foot (610 mm) Trac-two places, one at each end of Trac. 4 foot (1219 mm) Trac-two places, one at each end of Trac. 8 foot (2438 mm) Trac-three places, one in the center and each end of the Trac. 12 foot (3658 mm) Trac-four places, one at each end of Trac and four feet from each end. Remove all burrs from the Trac, insulators and copper buss bars. Push copper buss bars into the insulators 1/2" (13 mm) from end of Trac. NOTE: After completing Step 4, buss bar insulators should be flush with the Trac channel ends, and copper buss bars should be cut back from each end of Trac a minimum of 7/16" (11 mm) to a maximum of 1/2" (13 mm). If this is not the case, make appropriate modifications. Reinstall the dead end fitting and tighten screw. IMPORTANT: After Trac has been field cut make certain that each 4' (1219) section or less in length has one mounting hole spaced a maximum of 6" (152 mm) from each Trac end section. [. . . ] Portland PENNSYLVANIA Elmer Schultz Services Philadelphia 215-627-5401 FAST Comm. Service Philadelphia 215-288-4800 GCS Service Pittsburgh 412-787-1970 717-236-9039 610-376-5444 503-231-7171 503-624-0890 419-385-9121 518-563-3200 315-422-9271 Armstrong Repair Service Houston 713-666-7100 Commercial Kitchen Repair Co. San Antonio 210-735-2811 UTAH La Monica's Rest. Service Murray 801-263-3221 VIRGINIA Daubers Norfolk Daubers Springfield WASHINGTON Restaurant Appl. [. . . ]